Jump to content
SAU Community

Recommended Posts

HI THESE PARTS HAVE GOT TO GO!!!!!!!!!

SMS ME ON 0400200179 TO NEGOTIATE, EVERYTHING MUST GO!!!!!

Carbon Fibre 3D GT Wing $685 retails over $950

Nismo Stainless Carbon Fibre Muffler 3" Cat Back Exhaust System $600

Nismo Rear Suspension $100

Blitz "BIG" Boost Gauge $125

Blitz Exhaust Temp Gauge $140

Blitz Water Temp Gauge $140

4" Catalytic Convertor $130

Pierburg 400Hp+ External Fuel PumpsX2 $90 each

HKS (Green) Twin Pod Air Filters $120

Momo Corse Steering Wheel with Boss Kit $200

Pioneer P6550 In dash DVD Player (Touch Screen Like NEW) $2200 retails at $3599

Clarion 12" Subwoofer in Box $135

Small Amplifier to drive Sub $75

R33 GTR

Standard Sideskirts $200

Standard Mirrors $125

Standard Side Indicators $30

Standard Dash Instruments (34,803klms) $315

Standard Piping $135

Standard Fuel Rail $20

Standard Turbo's ( 1 missing rear wheel, no shaft play) MAKE OFFER!!!

Standard Oil Pump $115

Standard Oil Baffle $50

Standard Cam Gears $30

Standard Cam Cover $90

Standard Shifter $45

Link to comment
https://www.sau.com.au/forums/topic/50679-gotta-go-assorted-parts-gtr-others/
Share on other sites

  • Replies 50
  • Created
  • Last Reply

Top Posters In This Topic

got a pic of the standard shifter?

will it fit and rb25det 5spd?

does it come with the circlip to hold it in the gearbox?

cheers

dave

not too sure as to whether it comes with circlip, dunno whether fits Rb25det or not

Are the nismo exhaust and suspension to suit R33 GTR???

hi both are for R33 GTR, exhaust system is like new very polished with carbon fibre exhaust tip with nismo stamped all around the tip with stainless chrome look, can have both together for $650. SMS 0400200179

Pierburg 400Hp+ External Fuel PumpsX2 $90 each

Would these fuel pumps be suitable for a gtst. Also, would it be any hassles in installing them.

cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • What about if you just give it direct 12v and earth?
    • Hi guys . Can someone help me  I bought an Android screen for my Nissan fuga but it won't turn on   
    • My guesstimate, with no real numbers to back it up, is it won't effect it greatly at all.its not a huge change in position, and I can't see the air flow changing from in turbulence that much based on distance, and what's in front of it. Johnny and Brad may have some more numbers to share from experience though.
×
×
  • Create New...