Jump to content
SAU Community

Recommended Posts

The drivers side power window has been slowly dieing and is now completely dead and wound all the way down too, so I can't really drive anywhere and leave it :D

I've pulled out the mechanism that all the buttons are on and checked the wires which visibly look ok, all other buttons on it are functioning fine.

Any ideas what parts I'm looking for, is the mechanism with all the buttons on it the actual motor or is that a seperate part?

TAI!

Link to comment
https://www.sau.com.au/forums/topic/50963-broken-drivers-power-window/
Share on other sites

Had the window been going down on a strange angle b4 that, i had the nylon roller break on me in the runners. Made up a new one b4 it put too much stress on winder motor. Also their may have been a loud bang if runner came out of balljoint. If not then i'd say ur motor is faulty. Cheers

most likely the switch....same problem happened to me. Because the switch was faulty (the drivers side has the 2mode switch...hold down/up to operate or just one touch for automatic) the switch would remain on and so burnt out the motor...so new switch and motor - $150 each. Then my switch needed to be rebuilt so add another $150. Note that there is a difference in switches...my '93 R33 series 1 switch was different to normal...something about a change is design between series....

Easiest way to find out would be to get a friends driver side button thingo, pull it out (its only 1 screw from inside the handle)unplug it and then plug it into your door. If its still no go then your window motor is fkt. My mate had a window motor replaced on his r33 but the guy didnt' put in a skyline one because he couldn't find one, so he popped in another window motor and the window used to go up like 3 times faster than a normal skyline window motor hehe.

same thing happened to me tonite. I used to hit da door quite a few times and it used to come up. But now i've tried everything and it won't go up. i'm hoping it is only the switch because it neva has a problem going down. but $150 for a new switch??? can i get dem ne cheaper??? or any way just to trick it back up and never use the window again?

my power window hasnt been workin for weeks now and its bloody anoying when u go drive thru or need to talk to someone. wat u do is flick the switch up a couple times till u hear the motor turn and then help it out by pulling up on the window with ur hand. or disconect the motor from the switch and run alternate power to it. mine didnt seem to work when i did that so i assume my motors stuffed not my switch.

JAPCAP -- any chance u could find out what motor that was?? im sure theres other motors out there that would fit. maybe 200sx motors??

  • 5 years later...

It always is the power window regulator and its a common problem (& no, it is not the switch). I replaced mine 3 years ago with a second hand one I found for 75$. Did it myself its not too hard. The damn thing just happened yet again n i got a quote for one and its going to be 195$ for the part now. Thinking of trying to repair the old one this time, its the little bit of carbon pad that gets worn off, the mechanism is completely find asides that. Its a very long shot, will let you know if I have any success with it.

post-75459-1280102457_thumb.jpg

had the same problem with my swich, found that the lever under the button to acivate the upward swich was broken, would go down fine but wouldnt go up. ended up buying another p/w swich for $50 havent had problems since

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
    • Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
×
×
  • Create New...