Jump to content
SAU Community

How Strict Are Victorian Police On Powerful Vehicles Particulary The Skyline


Recommended Posts

  • Replies 47
  • Created
  • Last Reply

Top Posters In This Topic

duh, read all the other threads about everyone whinging that the cops are crackign down on them because they drive R33 GTSt's while on P Plates.

A stock R32 GTSt straight out of the factory will not go over the power to weight ratio... however, we all know you're not gonna leave it stock (not for long) and the cops will know that too. Just don't attract attention to yourself, and you'll be fine. I know guys who've driven Soarer TT's and Supra TT's on their P's and never been pulled over.

So if i were to install an exhaust system into the skyline and i was caught crusing round, to what extent would they go too to check the power of the car? Do they dyno it or do they just give you a ticket on the spot. Once being caught does the car become impounded or does the exhaust have to be taken out and replaced with the stock one? So what about just a tip does that still add performance, but what about noise aswell does it still have the same rumbling noise?

its not that bad... they either give you a minor defect, major defect and an EPA notice...

EPA is stuff like too noisy, bad emissions etc.

minor defect is stuff like blad tyres etc

major defect is like driving with a T-Wing so wide and sharp that it could lob pedestrian heads off if you got too close to the kerb.

Your car gets impounded if you get caught on a speed gun doing 158 in a 50 zone while in an illegal street race (don't ask).

Police can issue you defects at their discression, as theoretically they know better than you do. For example a police officer tried to issue me a ticket for having an oversized intercooler (which was in fact my air con radiator)... he ended up giving me a driving without a license fine of $50 after I informed him it was a non turbo... but you get that. Living in Glen Waverly with officer Petit running around dosen't help either :cheers:

if you get done, make sure they write down exactly what the defect is for, not just "driving an unroadworthy vehicle".

Most police don't know sh1t so if you get done for something you know is legal, make sure they write it down on the ticket, then go to your local police station and file a complaint. get them to look at the car and make a record of it.

Eg. if you have 18inch rims on a skyline (which is legal) and they defect you for that reason. Make sure they write "rims too big (18 inch)" on the ticket rather than just "rims too big".

It is hard to argue the case, the officer could say you had 19 inch rims and u must have changed them to 18 inch in the mean time. If you had the original defect notice/fine and then a police report less than an hour later, then you have a good foot to stand on.

Eg. if you have 18inch rims on a skyline (which is legal)  and they defect you for that reason.  Make sure they write "rims too big (18 inch)" on the ticket rather than just "rims too big".

It is hard to argue the case, the officer could say you had 19 inch rims and u must have changed them to 18 inch in the mean time.    If you had the original defect notice/fine and then a police report less than an hour later, then you have a good foot to stand on.

18 inch rims are definately illegal on R32s, not sure about other models. You are only allowed to increase diameter and width my 1 inch from the standard rims. It says so on the vic roads website.

As long as ur sensible and dont go driving around the city or dandenong or wherever every friday/saturday night, you wont have a problem with the police, except for maybe that cop that everyone hates.

So if i were to install an exhaust system into the skyline and i was caught crusing round, to what extent would they go too to check the power of the car? Do they dyno it or do they just give you a ticket on the spot. Once being caught does the car become impounded or does the exhaust have to be taken out and replaced with the stock one? So what about just a tip does that still add performance, but what about noise aswell does it still have the same rumbling noise?

the definition of a 'high powred vehicle' is based on the STOCK power at the flywheel and STOCK tare weight as quoted on your rego sticker and the factory power figures

so modding a car may change its legality from an EPA or Roadworthy point of view, but it doesn't change whether or not a car is deemed 'high powered' for P platers. this means a 300rwkw and roadworthy R32GTSt is fine for a P plater, but an R32GTR running airflow and exhaust restrictors so its makes 50awkw still won't be legal for you

You are safe with an R32GTSt... one of the main reasons i bought one when i was on my P's

cheers,

Warren.

v-spec r32 gtr's came with stock 17 inch rims which means 18inch are legal on gtr's. the largest wheels you could get on a gts-t were 16inch. there is some debate as to whether the fact that GTRs could get 17s also qualifies gts-t's however when most people go through compliance, most workshops tend to put the tyre/load ratings for the GTR (ie 225/50 R17) - or just ask them when you get compliance done.

i was just using that as an example, rim sizes have been discussed before and i don't want to start another argument here!!

v-spec r32 gtr's came with stock 17 inch rims which means 18inch are legal on gtr's.  the largest wheels you could get on a gts-t were 16inch.  there is some debate as to whether the fact that GTRs could get 17s also qualifies gts-t's however when most people go through compliance, most workshops tend to put the tyre/load ratings for the GTR (ie 225/50 R17) - or just ask them when you get compliance done.

i was just using that as an example, rim sizes have been discussed before and i don't want to start another argument here!!

Thats cool, i didnt know that r32 vspecs came with 17s but now i think i remember seeing them around.

the definition of a 'high powred vehicle' is based on the STOCK power at the flywheel and STOCK tare weight as quoted on your rego sticker and the factory power figures

so modding a car may change its legality from an EPA or Roadworthy point of view' date=' but it doesn't change whether or not a car is deemed 'high powered' for P platers. this means a 300rwkw and roadworthy R32GTSt is fine for a P plater, but an R32GTR running airflow and exhaust restrictors so its makes 50awkw still won't be legal for you

You are safe with an R32GTSt... one of the main reasons i bought one when i was on my P's

Are u 100% sure about mods not affecting the power to ratio limit on your p's? Cos i thought that if you got mods for your car for a gts-t r32 you would go over the limit and that then would be classified as a high powered vehicle. If what u say is true then the exhaust isn't a problem at all cos i dont care bout noise, I was just worried about the high powered thing, cos what they are doing now is if you r caught with a high powered vehicle (stock) the police take the car off you and sell them.

I suggest that BOTH MerlinTheHapyPig and xRHETTx have a look at the often quoted but seldomly looked at VicRoads website.

http://www.vicroads.vic.gov.au/vrpdf/rdsaf...afe/vsi%208.pdf

As for Skylinerz, well dude... I would be dotting my i's and crossing my t's with every single rule I could follow. Keep your car as legal as possible (print out the link above and learn the rules about mods).

An R32 GTS-t is VERY cool car to have and sounds awesome, even with a legal exhaust, it looks cool even at legal ride height, it goes well even with just a few mods. 18yos these days are so lucky to be able to have cars like this as an affordable option. Be thankful and careful. There is no real reason to have an illegal car and remember that the cheapest speeding fine is more expensive than the drags at Calder or a trackday at Sandown and I know which one I would prefer.

haven't read through the whole thread but judging by the title here's my experiences:

twin turbo supra:

- 3 defect notices including 2 major and 1 minor

- required to furnish engineers certificate

- 3 power to weight fines

- full mcleod epa

(all this within two months of owning the vehicle)

r32 gts-t skyline:

- no defects

- no power to weight fines

- no epa notices

- 5+ police pullovers

(i have been driving this car for 2 years)

i am on my p's and live 5 minutes around the corner from knox. im just stating the facts and accept the fact that i am willingly driving a car that im not meant to. to the best of my knowledge i am allowed to drive the r32, but not the supra based on the factory specs.

Are u 100% sure about mods not affecting the power to ratio limit on your p's? Cos i thought that if you got mods for your car for a gts-t r32 you would go over the limit and that then would be classified as a high powered vehicle. If what u say is true then the exhaust isn't a problem at all cos i dont care bout noise, I was just worried about the high powered thing, cos what they are doing now is if you r caught with a high powered vehicle (stock) the police take the car off you and sell them.

they are correct. my skyline is fairly modded, enough to say it would be over the limit, but i have no police trouble because they look at the factory specs.

my supra on the other hand is lightly modded, only with filter, exhaust and boost controller, so with or without mods, im game over.

i see u live in glenny, close to knox. if u do decide to get a hipo car, dont come down this way. no matter how nicely u drive or how polite u are u will get pulled over here.

1. driving 60kmph on stud rd. got done.

2. reversed out of driveway, went down the street, 10 houses from mine, cold engine doing about 10-15kmph. got done.

I suggest that BOTH MerlinTheHapyPig and xRHETTx have a look at the often quoted but seldomly looked at VicRoads website.

http://www.vicroads.vic.gov.au/vrpdf/rdsaf...afe/vsi%208.pdf

Done.. I am wrong, we both are actually, legally you can have any diameter wheel on a car as long as the overall diameter of the wheel and tyre is no more than 15mm different to the stock diameter.

As far as width of wheels, i was right, 25mm wider than widest stock wheel.

Now i will stop post whoring. ;-)

point noted..

yeah i've read the vicroads link before, I must have been confused between the width of the wheel and the diameter.

I was just using that as an example though.

Be warned about printing out regulations etc, if the cop is just going to give you a slap on the wrist and is happy to overlook a few things, don't wave "the book" in his face coz he'll think you're a smartass and just try and find more stuff to defect you on

one thing about the p/w ratio, there is a coresponding capacity to weight ratio that your not allowed to exceed.

My mate got pulled over by mr p for speeding and he was driving his bt1 vp como 5.0ltre, which is illegal for p platers. But all he got done for was speeding. Now i dont know whether this was just uneducation on mr P's behalve or what it could be. But this same officer has also fined many people for being over the power/weight limit in sr20det powered cars (use ur imagination :()

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
×
×
  • Create New...