Jump to content
SAU Community

Recommended Posts

I just had my accessory belts changed and the cooling system flushed and replaced coolant with Nissan Long Life Coolant.

Now when I drive it the car cuts out at random times. Happened 4 times today, once as I was just travelling normally, again when in traffic (on the freeway so in 1st gear), again once stopped at lights after going down freeway and again when turning corner into driveway. So all different conditions.

It used to cut out before when warm and stuck in freeway traffic but hadn't done that for a while.

I can't see how flushing the system and changing coolant could cause this problem.

Any ideas?

Cheers, Al

Yeah as in stalling and turns off without warning - the revs just die like I turned the key off

It got better today only stalled once on the way to work and twice on the way home.

I am thinking it could be something got wet when they flushed the radiator - would that cause the problem?

I have the factor BOV

I am thinking it could be something got wet when they flushed the radiator - would that cause the problem?

I have the factor BOV

Yeah definatly!

My Vl had the same problem - I could never find it and didn't want to spend any money, I just popped the bonnet on a really hot day and left it to dry for a few hours.

Allways did the trick - from working on the cooling system I'd say crank angle sensor maybe?

Worth unplugging everything and giving a spray with crc.

Maybe Air Flow meter plug?

Good luck!

Thanks for the replies and will try that on the weekend (hopefully it will be warm enough)

Stopped the problem on the way to work though just by putting the air-con on to keep the idle revs higher (this was after 3 stalls)

Cheers, Al

Check the idlin speed of ur car..should idle at 800 revs or so...

if it not then ur idle needs adjustin.

Where does the temperature gauge sit?

Does it idle rough ?

Cant see something wet bein the problem at this stage as the car engine would have dried out by now.

Red Sky,

This exact same thing happened to me in my R31. The sudden change of coolant has caused your system to break down more rapidly than with the water or low quality coolant you had in there.

Get the CO2 Sensor checked, and if its corroded/dirty get it cleaned. Get your water pump checked too. Should fix the problem.

Where does the temperature gauge sit?

Does it idle rough ?

Idle speed appears okay and the temperature gauge is normal.

Will get the O2 sensor, etc checked out though

Cheers, Al

Thanks again for the suggestions and it gives some things to try.

It hasn't really done it as much this week so maybe it was something that got wet or has just sorted itself out. It didn't like the 40 degree heat today though, nearly cut out a few times but didn't since the air-con was on.

To answer questions, it mainly stalls when slowing down to a stop such as on the freeway, stopping at lights although has done it when turning into my driveway (can't turn the damn thing since power steering disappears !!!)

owned

Haven't done the 100,000kms service yet as only done 77,000kms so far. Getting it serviced by an import specialist next time so will get them to check it all out then.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
×
×
  • Create New...