Jump to content
SAU Community

Recommended Posts

omg so not happy jan i had been looking for these for the last month or two and couldnt find a set. yesterday at about 1pm i put a deposit on a set of PII's annoying :D

gl with the sale dude if it had have been a couple of hours earlier i probably would have bought them

hi just want to know if u r getting in other volk rim like..GT-P, GT-C OR ANY OTHER TE37..

with this chanllenge wheel. the width is only 8 inc.. for both front an back rite??? so do u think i can fit 265/35/18 at the back???

if they fit..i like to offer $1800...let me know i can transfer the fund

thank

happy new yr

18" Rays Volk Challenge Wheels

Plenty of treads on tyres ( see pictures )

Bridgestone Tyres

F: 225/40/18    R: 235/40/18

F/R: 18 X 8J PCD114.3 +45 5 holes

$2000 Delivered

Direct from Japan, 2 weeks delivery on order.

  • 1 month later...
Also, be careful with that offset...

18 x 8 (+45) clearing the 4 pots on an R33 Gtst - I don't think so...

GTST should get offset in between 30 to 40 ( Better to go low than high because its easier to roll the fenders than adding spacers)

hmmm...official site recommendation -

SKYLINE 1880 +36 225/45R18 C 1890 +36 225/45R18 C

thanks guys,

yeah was a bit sus bout the offset too, but was assured it would fit gts-t.

made sure that a condition of the sale was that i would be refunded if this turned out to be incorrect.

it would be greatly appreciated if someone from adelaide would be willing to trial fit onto an r33 (i have standard susp. with lowered springs) before the rims are sent over here to melbourne.

please pm me if you would be willing to help out.

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
×
×
  • Create New...