Jump to content
SAU Community

bigest power

jas/slo32

By jas/slo32,
in General Automotive Discussion

 Share

Recommended Posts

LTSJayce Veteran

LTSJayce

Posted
Posted
what skylines in australia have the most power at the wheels?both gtr & gtst?

Are you talking outright figures?Or road rego'd,dyno-queen,drag car(which would prolly be the outright record,I'm guessing...)?I think RB30-POWER would be right in saying Mario's R33,GTR-700,would be it,but then again,I've never seen an official dyno sheet...drag racers are really coy about letting figures be known!Most are happy to talk up their "easy 800kw" cars,but LeeWah's is about the biggest hitter(GTR) in Oz,that I can think of,that has a printout to prove it.

Link to comment
https://www.sau.com.au/forums/topic/61157-bigest-power/#findComment-1156915
Share on other sites
Leewah Veteran

Leewah

Posted
Posted

In Oz, there is without a doubt the Mario's GTR700 is the most powerful.

I guess you could split this into 2 different categories, race and street regoed cars.

In the race category I'd put the following (as judged by ETs and trap speeds):

GTR700 R33 GTR

Kier Wilson R32 GTR

Munro R33 GTR

In the street category, I'd include the following:

Theo's R32 GTR

LeeWah R33 GTR

RacePace R33 GTR

Ice Performance R32 GTR *

IWIN R33 GTR *

* - Has not recorded a time on the drag strip but publically run dyno runs have been recorded.

Link to comment
https://www.sau.com.au/forums/topic/61157-bigest-power/#findComment-1156956
Share on other sites
Leewah Veteran

Leewah

Posted
Posted

Nowhere did I mention I had more power than IWIN. IWIN was mentioned on the list of most powerful cars.

I was only judging a cars power by drag strip times as dynos read differently depending on calibration so the only way of getting a half accurate reading is at a drag strip. IWIN (as far as I know) has not made a pass down the strip so it was hard to tell where it would fit in the World of Powerful GTRs.

Link to comment
https://www.sau.com.au/forums/topic/61157-bigest-power/#findComment-1157143
Share on other sites
LTSJayce Veteran

LTSJayce

Posted
Posted

A while ago,the guys from Sub Zero in QLD had a head kicking GTS-T...can't remember power figures exactly,but it was a tough unit...I'll zip through my Zoom mag's to see if I can dredge it up,even if it's only a reference point...

Link to comment
https://www.sau.com.au/forums/topic/61157-bigest-power/#findComment-1158821
Share on other sites
Leewah Veteran

Leewah

Posted
Posted
A while ago,the guys from Sub Zero in QLD had a head kicking GTS-T...can't remember power figures exactly,but it was a tough unit...I'll zip through my Zoom mag's to see if I can dredge it up,even if it's only a reference point...

That would have been TRY-09 which ran some very tidy numbers in QLD. There was an article for it in HPI awhile back too.

Oh and OBEHAVE and BIGPSI (I believe which is a GTS-T) are another couple powerful GTS-Ts running around and pulled nice numbers on the strip. There is also another red 3L GTS-T running around Melb owned by a certain FunBoy looking Fang Artist.

I was only quoting GTRs as I don't follow the GTS-T scene as much. If someone else wants to list the most powerful GTS-Ts going around, feel free :(

Link to comment
https://www.sau.com.au/forums/topic/61157-bigest-power/#findComment-1158920
Share on other sites
RB30-POWER Mentor

RB30-POWER

Posted
Posted
thanks for the input. I have an r32gtst that makes 779.7rwhp hopefully in the next couple of months ill run it down the strip.  thats why i asked for gtst as well.

Frig, that is a big number. Obviously not a RB20.

Any specs you want to share, RB26DET or RB30DET?

Link to comment
https://www.sau.com.au/forums/topic/61157-bigest-power/#findComment-1160532
Share on other sites
LTSJayce Veteran

LTSJayce

Posted
Posted
thanks for the input. I have an r32gtst that makes 779.7rwhp hopefully in the next couple of months ill run it down the strip.  thats why i asked for gtst as well.

HOLY CRAP! I take it there's a dyno sheet to back you up? That can't be a RB20.. Whadda ya got? Or are you waiting to spring a suprise on someone?

Link to comment
https://www.sau.com.au/forums/topic/61157-bigest-power/#findComment-1161174
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Duncan's V37.......race car?

      By MBS206 · Posted

      Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • RP1421
      S15 Spec R

      By RP1421 · Posted

      As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...