Jump to content
SAU Community

Recommended Posts

  • Replies 310
  • Created
  • Last Reply

Top Posters In This Topic

pizza granny smith style,

from breakfast salad bar in morning grab lebanese bread, onion,olives (from garden salad), bruscetta mix and grated cheese.

lunch time: get BBQ sauce of shelf, add in dash of tomato sauce and tobasco (if you want it hot)

spread sauce over good side of lebansese bread.

add thin layer of grated cheese

add mixed ingredients depending on taste, eg olives, salami,onion,pineapple and bruscetta mix

add top layer of grated cheese

toast in oven for 15-20 min or until golden brown and cheese melted.

enjoy!

Kewl recipe time

Take a 3x3cm block of cheese.

Cut a plug out of centre and remove half

fill block with tomato or bbq sauce replace other half of plug.

Roll in batter

Deep fry

Enjoy

Lay on couch and digest.

Kewl recipe time  

Take a 3x3cm block of cheese.

Cut a plug out of centre and remove half

fill block with tomato or bbq sauce replace other half of plug.

Roll in batter

Deep fry

Enjoy

Lay on couch and digest.

i'm gonna be sick!

i had this weird craving for battered fish last night .... i usually hate battered fish - usually get mine grilled as batter tastes like tipping oil down your throat .... but last night that was all i could think about :drooling:

Yeh i think last time we met we were sitting on some stairs feeling seedy and squinting in the newly risen sunlight :drooling:

Nahh unfortunately im not and no im not an it boy either. thats my bro, thin as and eats total crap.




  • Similar Content

  • Latest Posts

    • Hi guys . Can someone help me  I bought an Android screen for my Nissan fuga but it won't turn on   
    • My guesstimate, with no real numbers to back it up, is it won't effect it greatly at all.its not a huge change in position, and I can't see the air flow changing from in turbulence that much based on distance, and what's in front of it. Johnny and Brad may have some more numbers to share from experience though.
    • Which solenoid? Why was it changed? Again, why was this done? ...well, these wear..but ultimately, why was it changed? Did you reset the idle voltage level after fitment? I'm just a tad confused ~ the flash code doesn't allude to these items being faulty, so in my mind the only reason to change these things, would be some drive-ability issue....and if that's the case, what was the problem? Those questions aside, check if the dropping resistor is OK ...should be 11~14 ohms (TCU doesn't throw a flash code for this) ~ also, these TCU designs have full time power (to keep fault code RAM alive), and I think that'll throw a logic code (as opposed to the 10 hardware codes), if that power is missing (or the ram has gone bad in the TCU, which you can check..but that's another story here perhaps).
    • Question for people who "know stuff" I am looking at doing the new intake like the one in the picture (the pictured is designed for the OEM TB and intake plenum), this design has the filter behind the front bar, but, the filter sits where the OEM duct heads into the front bar, and the standard aperture when the OEM ducting is removed allows the filter to pulled back out of the front bar into the engine bay for servicing, a simple blanking plate is used to seal the aperture behind the filter This will require a 45° silicone hose from the TB, like the alloy pipe that is currently there, to another 45° silicone hose to get a straight run to the aperture in the front bar Question: how will it effect the tune if I move the MAF about 100-150mm forward, the red is around where my MAF is currently, and the green would be where it would end up Like this This is the hole the filter goes through  Ends up like this LOL..Cheers    
    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
×
×
  • Create New...