Getting Wires from Engine Bay to Cabin

[Sydneykid]

Hi guys, anyone found a good grommet (or two) to pass wires through from the engine bay to the cabin?

[someonestolecc]

I second that. Mine leaks in the cefiro. I tried Clarks Rubber grommets but had to modify it and as a result it ain't perfect.

[Lone]

Ive feed some wires through the top driver side section of the engine bay to under the driver side dash..

[Terminal]

yeah i found a large rubber section that the main wiring loom went through. i passed my power cable for my amp through it and it went along the inside of the front right qtr panel and popped out right at the battery. dont know if you want the wires going that far though.

Its right up under the dash, behind the acc. pedal

[Jay95R33]

Yepp, that's the one that I used too (top passengers side of the engine bay). You can get to it from the engine bay, or by taking off the plastic inner guard.

Should be heaps of room to pass the wires through. Just need to do the old coathanger through the grommet trick.

J

[PranK]

i went semi dodgy, i squeezed mine through where the air con drain is

[someonestolecc]

Seems I mis-read the question.

I need an actual grommet

[Sydneykid]

Yepp, that's the one that I used too (top passengers side of the engine bay).  You can get to it from the engine bay, or by taking off the plastic inner guard.

Should be heaps of room to pass the wires through.  Just need to do the old coathanger through the grommet trick.

J

This sounds like the one I need, ends up close to the ECU. Any chance of posting a picture J?

[Jay95R33]

Do'h - just realised what I wrote... I meant to say it was the top DRIVERS side of the engine bay

J