Jump to content
SAU Community

OMG WTF 15yr rule GOOOONE!!!!1!!one!!11


Recommended Posts

L11/05

Monday February 7 2005

MINISTER ANNOUNCES CLOSURE OF CAR IMPORT LOOPHOLE

A plan to tighten Australia’s vehicle importation laws that will reinforce motor vehicle safety and emission standards was announced today by the Minister for Local Government, Territories and Roads, Jim Lloyd.

“The Government is closing a loophole that has enabled mainstream cars over 15 years of age to be imported in commercial quantities, and not subjected to safety and emission certification,” Mr Lloyd said.

“Importers of these cars were using an exemption that allows hobbyists and enthusiasts to import classic and historic cars. This exemption exists as these vehicles generally perform low mileages and are limited in numbers, and therefore represent a minimal risk to overall Australian vehicle and safety goals.

“Without such an exemption, the private importation of these types of older, collectible cars would become uneconomic.

“The closure of this loophole will only apply to those vehicles which do not fit in the classic and historic category, thus preserving the ability of hobbyists and enthusiasts to obtain older classic cars and historic vehicles.”

Mr Lloyd said a transitional arrangement would be provided for other vehicle importers who had current commitments to bring in vehicles under the old rule.

“The changeover is being introduced gradually, to allow importers and consumers time to react to the revised focus of the exemption,” Mr Lloyd said.

Under the new rule:

Vehicles manufactured before 1 January 1989 may be imported without restriction.

Vehicles built during 1989 (or later) will need to qualify under the Registered Automotive Workshop Scheme (RAWS) and will need to be certified as complying with Australian Design Rules (applicable at the date of manufacture). To qualify under RAWS, vehicle models must meet the specialist and enthusiast criteria.

The buffer period (between collectible vehicles and mainstream vehicles) will be gradually extended over time – up to a maximum of 30 years.

A transitional arrangement will also be established. Those importers who have already made a financial commitment before today on a vehicle manufactured in 1990 intended for future import, will be allowed to bring the vehicle into the country under the old rule up to the end of December 2005.

“This new rule will re‑instate a ‘level playing field’ within the industry. Vehicles supplied to the same market will be subject to the same regulatory environment, substantially reducing cost pressures on mainstream businesses,” Mr Lloyd said.

Media inquiries:

Mr Lloyd’s office: Fiona Telford 02 6277 7060

Technical inquiries:

Department of Transport and Regional Services: Justin Bryan 02 6274 7426

OMG.jpeg

OMG!! The pope is reading this thread!!

never seen him so enthusiastic in my life....hes keen for a high hp gtr........thats never gonna happen now. His realised this and thats why hes now in hostpital, theres not much left to look forward to for him.

Sorry, this thread wasn't really constructed for serious conversation..

I motion to the council that it may be removed.

Motion granted... This thread has served us well these past 12 hours and hencewith shall be presented with a gold padlock...

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...