Jump to content
SAU Community

Recommended Posts

Simon, tricky to set up I believe and what is wrong with the normal power fc?

Pete has good hp and excellent driveability with the normal one using Z32 afm's.

I would suggest that if you want the no AFM route , use Autronic, or heaven forbid..wolf. Just be prepared to pay for the tuning on the latter... :D

Cheers

Ken ( now wearing flame suit)

Simon, also consider the fact that the Datalogit software used in some shops may not support the D-Jetro.. I cannot get my PFC Pro tuned anywhere on Datalogit for the same reason... If you're happy to tune via h/c and want launch control I'll do ya a swap for a standard PFC... I believe R32 and R33 GTR PFC's are interchangable.. :D

Cheers

Brett

i recommend you stick with the afm and ditch the map sensor idea... its a much more accurate way of measuring the mass of air coming in. drive-ability will suffer if you switch to a map sensor - and you will need a retune for any changes to the engine if your running a map sensor

I'm very interested to know about Power FC djetro also as I have noticed from the photos of my GTR that it does not have afm's. I would suspect it's running a map based ecu such as HKS FCON? The cost of buying 2 afm's and a std power fc would far outweigh the cost of a djetro unit....

540 isnt enough :)

$760-780 for two knew z32 afms with plugs from repco, not sure on there limit

(they read about 4v at 530rwhp so plenty of range left) but if your playing in this ball park then money should not be your issue as you will be spending sh.. loads on everything else anyway

ie clutch, gearbox, internals, fuel system etc etc

But you would need a retune if you changed something anyway. even with afm power fc.

not quite, say you take down the boost pressure, or change the boost controller arrangement ie wastegate creep control, then on a map based car it will need a retune

whereas on an afm based engine, it measures mass of air directly with the afm and thus knows if boost has been changed etc..

of course any big changes and you will need a retune on a afm based car as well..

but the big point is afms will give a better tune then map sensors, as they are more accurate in measuring the air coming in, i agree with what pnblight has said, stick with either twin z32's or rb25 afms :)

$2k deal for engine management sounds like a steal to me ,as ecu and air/fuel control is everything if your trying for 540 plus rwhp i would be spending some series money on management and not looking to cut corners ,especially if you want this car street drivable

i think you will find alot of tuners would tell you to spend the money on management over many other thing first

but this is only my opinion and i have had great results with my pfc and afms, went you get the right guys tuning (Lumpy is the man for pfc)

IIRC the Apex PFC weak point is not being able to work with d-jetro...not sure on the Apexi Pro version.

Regarding the F-Con V Pro it's not a problem thus tuners' choice. Not sure on the F-Con SZ/SA...but I think it can also run d-jetro as it can be converted to a full-com but don't quote me on it. My December Option issue has gone walkies...but there is a comparison in there outlining the strong and weak points of all the Japanese CPUs. F-Con V Pro obviously wins out right as the best, but question I ask many is do you really need something like a F-Con V Pro, unless your after 600ps+!

$2k deal for engine management sounds like a steal to me ,as ecu and air/fuel control is everything if your trying for 540 plus rwhp i would be spending some series money on management and not looking to cut corners ,especially if you want this car street drivable

i think you will find alot of tuners would tell you to spend the money on management over many other thing first  

but this is only my opinion and i have had great results with my pfc and afms, went you get the right guys tuning (Lumpy is the man for pfc)

Theres a few others i know of who can tune power fc just as well. cheers.

IIRC the Apex PFC weak point is not being able to work with d-jetro...not sure on the Apexi Pro version.

Regarding the F-Con V Pro it's not a problem thus tuners' choice.  Not sure on the F-Con SZ/SA...but I think it can also run d-jetro as it can be converted to a full-com but don't quote me on it.  My December Option issue has gone walkies...but there is a comparison in there outlining the strong and weak points of all the Japanese CPUs.  F-Con V Pro obviously wins out right as the best, but question I ask many is do you really need something like a F-Con V Pro, unless your after 600ps+!

Hi there, Tuning an F-Con V Pro in Perth is a problem as we do not have someone here that is capable at present, thus my intention to get rid of the F-Con CPU. In a quest for saving a few dollars I considered in the light of not having AFM's it might be cheaper to seek out a MAP based ECU to replace the F-Con with that can be tuned locally. I'll be happy with a clean 400rwhp, so MAP sensors are not a necessity.

Looks like I might just have to fork out for z32 afm's and a std Power FC...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...