Problem car wont start up

[[[d a n n y]]]

Hey peeps i just did a DIY job on the timing belt camcovers and plug covers painting them..

now i got a problem..

the car wont start up..

it clicks but no and all..but just wont fire up..

what's going on here?

any suggestions

any suggestions of where i might went wrong?

would touching that round thing in the timing belt cover would have resulted this?

ps. need reply back asap

[PlasticStan]

]']Hey peeps i just did a DIY job on the timing belt camcovers and plug covers painting them..

now i got a problem..

the car wont start up..

it clicks but no and all..but just wont fire up..

what's going on here?

any suggestions  

any suggestions of where i might went wrong?

would touching that round thing in the timing belt cover would have resulted this?

 

ps. need reply back asap

Did you plug the CAS (Cam Angle Sensor) back in. This will prevent the engine starting if it is not plugged in.

Simon.

[JH32]

That "round thing" on the front of your timing belt cover is quite important ! :wassup:

It's your crank angle sensor and it affects the timing. You might want to get it checked out, and as Stan says, make sure its plugged in !!

[mjfawke]

Or you could just check the error codes on the computer...

[[[d a n n y]]]

ok guyz thanks for the good advice..

the timing was a bit off so the car refused tp start

after played with the timing a bit..

it started up

but i think i need to get the timing belt done correctly.