Jump to content
SAU Community

Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

Maybe once this mystery is solved we can research the meaning behind Toyota and Mitsubishi's engines, anyone hazzard a guess at what 1JZGTE or 4G63 stand for? :)

Have a look here for toyota ones http://www.toymods.org.au/tech.html

RB = Rough Bastard ?????

RB = Rude Bitch/Bastard ?????

& just for you Messiah, doesn't pH stand for percent Hydrogen ?????

how can a scale that starts at 1 and goes to 14 be a percentage? :(

Nah just to clarify pH, when a fluid is "ionized" it breaks off into negative and positive Ions. Water produces roughly equal ammounts of neg/pos ions and hence is neutral. Things like HCL (Hydrochloric acid) give out more positive ions than negative.... or was that the other way around.... but due to this its an acid

but u get the drift.

I find it comical that there are several sites that endulge in the whole Race Breed thing.  

All I can say is RB20E.... & the diesel RB28.... NOT what I'd call race breed personally.

.

dont forget the good old rb30e! :)

Racooo Breeedoooo!!11!

rd28.jpg

68kW/170Nm of track-tearing performance fitted to the equally apex-hugging NQ Patrol.

Although, admittedly this is actually an RD28 due to it being diesel rather than petty powered... :(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Good to hear. Hopefully you're happy enough not to notice when driving and just enjoy yourself.
    • I mean, most of us just love cars. Doesnt necessarily have to be a skyline.
    • Did you pick up a manual cluster to remove the position indicator?  (Pretty sure the 34 has the gear position in the cluster, but it's been a while)
    • Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
    • 440s will support well over 400HP on petrol, which is a decent place to be for an RB20. 230+rwkW. Will be a safer bet for idle/low load. 550s would be nice for the extra headroom. I've made the same decision with mine (Neo25). 1000s are probably too big for the Nistuned ECU, so I have some smaller ones.
×
×
  • Create New...