Jump to content
SAU Community

Recommended Posts

Sniffy,

Yeah, just keep a bottle handy for the occasions when you can't get to a decent servo.

51Jay,

Thanks for the details on the location and price, what is your suggested mixing ratio, I've heard between 15-30%.

Giz01,

Couldn't they find a decent car to perform the test on?? Just kidding. I think it is sensible when racing to add it just for added protection.

Ait,

Your the one who has been running your car on 98+booster, notice any difference? Just means that we don't advance out timing as much as we would with 100RON fuels.

Everyone,

I don't like to get covered in any chemicals, whether cancer causing or not, just be sensible and don't sniff or drink it.

See'ya

:burnout:

  • Replies 64
  • Created
  • Last Reply

Top Posters In This Topic

If the octane rating of Toluene is really 122 then adding

10% gives 100.4

15% gives 101.6

30% gives 105.2

I've decided to keep the tuning for BP 98 octane and add 10%

when racing on full boost as a hedge against detonation

51Jay,

Don't want to burst the buble but at 20% mix the RON improvement is +2.5 and 30% is the maximum recommended, therefore +3.7RON is the best your likely to get. This is taken from an article in a magazine and tested on a knock engine. This is still more than enough to protect you from detonation, therefore it is still worth doing.

See'ya:burnout:

Doesn't work like that I'm afraid, life would be so much easier if it did. The fact is you can't work it out. The only way to determine the RON(research octane number) is through the help of a $200,000 knock engine, which all oil companies use for testing of there fuel's RON.

Don't believe all of the bottles claims about there octane boosting ability either, the set there own scales which don't reflect well to real life. If you want guaranteed high octane then use an unleaded race fuel such as Elf or VP Motorsport Fuel 103, about 107RON, the highest you'll ever need to run in any normal car. With the higher octane you can advance timing and get more power also.

See'ya:burnout:

Originally posted by GTS-t VSPEC

51jay,

Toluene is good stuff, if you don't mid premixing it, just remember not to drink the stuff, some of the other guys use it as mouth wash. Go figure!:bahaha:  

See'ya:burnout:

thats cause we are tough, and have cast iron guts from drinking to much coke

Premium unleaded's like the BP Ultimate, Optimax etc. are supposed to provide better fuel economy due the increased fluid density. I don't know why an octane booster would improve the fuel economy, but if it does that's great. Not likely to offset the cost though at $20 per 60L.

See'ya:burnout:

Originally posted by 51jay

How do you work it out ??   I'm using 98 octane for the BP Ultimate and 122 for the Toluene which are the figures they claim and just multiplying and dividing the appropiate numbers

Roughly,

The BP ultimate 98 stuff would be a closer guestimate due to it having the lowest % content of aromatics.

The mixture of 30% toluene to 70% BP98 will yeild an approximate RON of 105.

Well the tune up + Toluene must have done something. Just back from Willowbank. My previous best 14.8 dropped it to 14.3 good enough to cream 3 x commydoors including a HSV Club Sport 5.0LV8.......Skylines 3...commydoors 0 :)

14.3 @95, 14.6 @ 99.7 ?? 14.8 @ 91

Was very hot, Track temp 42' Iwas leaving after 4 runs at 6.15 pm when a few other Skylines were just arriving. In retrospect I should have stayed on and run acouple more when everything had cooled down a bit.

MRE Still behind you in the mph, just couldn't make the 100.

I'm really looking forward to Wed night though, should be pay off night

GTS-T V Spec :) and especially Club Sports that do huuuuuge burnouts :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Nope.    Grab a varex and turn it down as you get close to home, win win? 
    • So, I've had my V36 for about a month now and have already copped an "excessive exhaust noise" notification from QLD TMR, reported by someone in my local area. It's a twin as per the original, and can have a bit of a throaty note to it when idling cold 😄 and if I do get up it a bit, it can be noisy, but it did pass a roadworthy inspection before sale, so.... ... but in the interest of being a good neighbour, I do want to quieten it down a bit. Is anyone here running a quiet aftermarket cat-back on their V36 or 370Z? And the big, bold question: does an aftermarket cat-back really make much of a performance difference on these cars?
    • The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
×
×
  • Create New...