Jump to content
SAU Community

Recommended Posts

Hey guys, I was talking to a few of you who said you would be keen for this cruise. All are welcome.

Meet: Spears Point Park (10.30am, leave at 11am)

Destination: The Haven (Terrigal) via Swansie

Once we are all down there we can decide if we go for another drive or if there is anything else to do. Suggestions welcome.

Oh and don't forget your UHF's....with batteries :) (will decide channel on the day)

Please post if you would like to attend.

Attending:

NYL83R

NZM.031

d-d

dean1285

wizard2k

Lenno

GRUNTN

GTS4dood

michadoo

Maybes:

Birnie

eXc

sneedsy + 5-7

DRFT32

sindows

OohArrGTR

Link to comment
https://www.sau.com.au/forums/topic/71512-newcastle-to-central-coast-15th-may/
Share on other sites

  • Replies 82
  • Created
  • Last Reply

Top Posters In This Topic

I just changed plans for a motorbike course from 1st of May to 15th of May because of a pub crawl on the Saturday night.  Guess I miss out again!

good on ya, make the course for the 8th :rofl:

Very nice choice - your right, they suit the car well.  Not too ricey and not too plain, just right!  Need to drop that she-bitch now.

thanks, and it will be getting lowered soon hopefully :P

:headspin: hmmm, the autosalon is on the sat and sunday, so if you wanted to see it you could go on the sat. Leaving sun open for cruising :rofl:

We are getting some good numbers for this cruise, it should be a good day.

Hey guys, I was talking to a few of you who said you would be keen for this cruise. All are welcome.

Meet: Spears Point Park (10.30am, leave at 11am)

Destination: The Haven (Terrigal) via Swansie

Once we are all down there we can decide if we go for another drive or if there is anything else to do. Suggestions welcome.

Oh and don't forget your UHF's....with batteries

Please post if you would like to attend.

Attending:

NYL83R

NZM.031

sindows

d-d

dean1285

wizard2k

Lenno

Maybes:

Birnie

eXc

sneedsy + 5-7

I dont know how to get to spears point park... i dont even know what part of newie that is... Im from the CC and will drive to newie and then back to the CC with ya'll....

Could you show me where spears point park is?

Cheers...

Also i dont have a UHF :D (N)




  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...