Jump to content
SAU Community

Recommended Posts

hey ppls

I tried to drive the ol girl just now, but the engine wont start up. All the assesories.. SAFC etc etc turn on fine, but when i turn the key it just ticks a few times then all the power turns off then back on. Where/what should I be looking for ???? I tried kicking the immobiliser button a few times incase its something to do that with.. didnt help

thanks heaps :)

Justin

Remove, clean and re-tighten Battery terminals. Remove Negative terminal, clean it and Battery post. LEAVE IT OFF. Remove positive terminal , clean terminal and Battery post.

REPLACE it and tighten. Now REPLACE and tighten Negative terminal. Smile, get in car, start it and drive away!!

If this does'nt work, examine other end of negative cable, for good Earth, before panicing.

hey ppls

I tried to drive the ol girl just now, but the engine wont start up. All the assesories.. SAFC etc etc turn on fine, but when i turn the key it just ticks a few times then all the power turns off then back on.  Where/what should I be looking for ???? I tried kicking the immobiliser button a few times incase its something to do that with.. didnt help

thanks heaps :)

Justin

Try taking both battery termianls off and cleaning the erosion out for them and try again, it sounds like a connection problem to me!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don't know it is due to that. It could just be due to load on track being more than a dyno. But it would be nice to rule it out. We're talking a fraction of a second of pulling ~1 degree of timing. So it's not a lot, but I'd rather it be 0... Thicker oil isn't really a "bandaid" if it's oil that is going to run at 125C, is it? It will be thicker at 100 and thus at 125, where the 40 weight may not be as thick as one may like for that use. I already have a big pump that has been ported. They (They in this instance being the guy that built my heads) port them so they flow more at lower RPM but have a bypass spring that I believe is ~70psi. I have seen 70psi of oil pressure up top in the past, before I knew I had this leak. I have a 25 row oil cooler that takes up all the space in the driver side guard. It is interesting that GM themselves recommend 0-30 oil for their Vette applications. Unless you take it to the track where the official word is to put 20-50w oil in there, then take that back out after your track day is done and return to 0-30.
    • Nice, looks great. Nice work getting the factory parts also. Never know when you'll need them.
    • Thanks @jtha7 I will have a look around tomorrow but it is a prick of a spot. These are some photos i tried taking 
    • I take it that the knock retard is from bearings tapping a little tune? Thicker oil is a fragile bandaid. You need a much bigger oil cooler and probably the bigger pump being discussed.
    • Hi @Chupapy i had several leaks from coolant pipes being corroded, i also had one leak on back of the head onto transmission. For me that leak was from the turbo water line. Follow the line to the back of the head The hose and metal pipe had perished these are the best pics I took of it at the time
×
×
  • Create New...