Jump to content
SAU Community

Recommended Posts

Today whilst driving, i had a bit of an accident, now as far as i know to this time, the accident is going to be 50/50. now in saying that, its sort of can be said that i do not have full comp. The damage is roughly 4k, :'( and its sort of going to stretch the budget a bit, well alot.

ill need a pair of headlights, bonnet passenger front guard, reinforcement bar, mspec front bumper ... :( im poor

Link to comment
https://www.sau.com.au/forums/topic/79613-had-a-bit-of-an-accident/
Share on other sites

Today whilst driving, i had a bit of an accident, now as far as i know to this time, the accident is going to be 50/50. now in saying that, its sort of can be said that i do not have full comp.  The damage is roughly 4k, :'(  and its sort of going to stretch the budget a bit, well alot.

ill need a pair of headlights, bonnet passenger front guard, reinforcement bar, mspec front bumper ... :( im poor

ahhh know the pain mate, my cars got about 6 grans damage all up :P, sucks bad.

its really hard to explain, and does anyone recomend an import yard in melbourne, preferably the s.e suburbs?

i drive a 95 series 1.5 r33 gtst

will post up tomorrow how it happened.

Hopefully it all does go smoothly, i did think about the front cut option also, would still need to get the parts painted tho.

sux to hear also jar, hard to get thru it all nice and smoothly. So hopefully it all goes well, its my b'day at the end of this month, so ill start hinting to my parents, lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...