Jump to content
SAU Community

Recommended Posts

Get on yellow pages online and search "car freighters". Ring around a few and get a guage on pricing as it can vary up to $2-300.

I dont think there would be a particular company that is going to take a lot more care than others because at the end of the day it all comes down to the driver who loads the car on the truck. If you are worried, get the person who is selling to remove the front bar and put it inside the car.

Link to comment
https://www.sau.com.au/forums/topic/80375-car-moving/#findComment-1462174
Share on other sites

i am not sure what kind of car u r buying but im presuming it is a skyline and presuming that it is not a very expensive one (i.e <20000) in light of that and considering the availability of skylines in brisbane, i would like to suggest that you consider simply purchasing one in brisbane. Not only are u able to inspect the car in person (unless u fly to melb which again requires u to fork out money) u also save on rego and inspection and transportation charges. Unless u can say the car in question is a truely unique one in one aspect or another....perhaps u should simply considering buying one in ur home state as it really saves alot of trouble and potential headache

Link to comment
https://www.sau.com.au/forums/topic/80375-car-moving/#findComment-1462259
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...