Jump to content
SAU Community

Recommended Posts

As per the title, does anyone know what's involved in doing this swap ??

I've got an R32 GTS-T ( RB20DET ) and want to install a Gearbox from an R33 GTS-T ( RB25DET ).

Would like to hear from people who have done it, know what's involved / required and what it cost's.

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/84573-rb25-gbox-into-r32/
Share on other sites

You sick, twisted individual !! Time for you to stop spending $'s on the 31 and buy a Penthouse mag then off to Kings Court for a "special" massage. I'll tell them you're cumming ;)

Yeah, hear something about needing the following changes:

- Different Tailshaft ( Which one, dunno ?? ).

- Different Crossmember ( Which one, dunno ?? ).

- Different Speedo Drive ( Heard something about a 94 Nissan Navara ?? )

I'm sure there are people who've done this on the forums.

My box is stuffed and I'd rather do this mod than waste big $'s on rebuilding the RB20 box !!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
    • I _think_ that one has a christmas tree or some other retainer spike into a hole in that panel under it. Come in under it with thin scredrivers and just pry it gently up. If you rip the ears off the retainer pin....so what? Just stick it back down after with a bit of race tape and carry on with life.
×
×
  • Create New...