Jump to content
SAU Community

Recommended Posts

My hicas light has started to come on after a bit of driving too. I've just put on an aftermarket steering wheel, but the bloke said that it should be ok.

I've checked the fluid level and it is all good, so i would have to guess that it is the steering wheel.

Anyone know a good place to go to get a boss kit for a momo steering wheel that doesn't screw around with hicas?

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-138880
Share on other sites

  • 2 weeks later...

I am having problems with my hicas... After about 15 - 20 minutes of driving, the light comes on. There's no noticable changes to the way the car drives, and I can see the rear wheels move ever so slightly while steering to full lock. The first thing I did was to top up the power steering.

I have been trying to get the diagnostics to appear, with no luck. Either I'm doing it wrong, or there's something wrong with a sensor like brakes or speed, etc... So just to verify my procedure:

1) Turn off car, leave in neutral

2) Turn it on

3) 20o left and right 5 times.

4) Pump brake 5 times

5) Press brake again

6) Drive (or roll, really) 5 metres ahead really slow.

1) From the time I turn on the car, to the time I start the 5m drive, how many seconds do I have?

2) In step 5, do I hold the brake in slightly and heel-toe it foward, or tap it in and out?

My car is a stock R33 '95 model. The 4WS appears to be fully electric.

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-172695
Share on other sites

i used to have this prob - just went away about a yr ago by itself.

whenever it came on, i just pulled over and restarted car... gone for another couple of weeks.

the only time it would come on for me was when doing long straight stretches of road that required next to no steering.

i used to drive a same long stretch of road frequently - 7 out of 10 times the hicas light would come on... ALWAYS at the same spot give or take 100m

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-172727
Share on other sites

and I can see the rear wheels move ever so slightly while steering to full lock.

im dont understand what you mean here? if you are saying your rear wheels move when you are not in diagnostic mode just sitting on the spot and you turn your wheel you are wrong!

Skyline 4ws only opreates when you are travelling and not stationary unless you are in diagnostic mode!

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-178026
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...