Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by caminperth

Lunch was great.. good to meet some of you.. well those that turned up anyhow..

Thought sitting between Dan and Lauren made me feel quite the little man.. hehehe :P

You thought you felt small.... I think I was probably the shortest person there.... and I'm not even that short!!!!! :P

Yeah Kym... Its always good to put faces to names... I am getting there slowly.... Each cruise or lunch I get to meet a few more people...

Strich9ine - came out pretty seedy didn't it.. hehehe... oh well.. I probably meant it that way subconciously anyhows.. :P

Niz - ahh - k.. Angel is the one who bought the front brace before I could get to it from PVA!!! Doh, would've given her shite about it.. :P

Guest
This topic is now closed to further replies.



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...