Jump to content
SAU Community

Recommended Posts

Originally posted by GTS-t VSPEC

Careful Cam, I'm know to call late at night and do heavy breathing:p

See'ya:burnout:

no probs paul - it'll be the most action i've had in ages! :P

man that sounds poor! hehe.. but it's true... *sob*

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

the **** look is for private viewings only. sorry to disappoint guys but im over the teeny bopper boob tube with shortest skirt possible stage - its either short skirt and full top or revealing top and jeans.

Originally posted by Nizmo

its either short skirt and full top or revealing top and jeans.

well.. i think i'd have to go with the revealing top and jeans..

as long as they are hipster jeans.. and there is a G on underneath..

hehe - so half and half hey niz?

paul - don't have anyone specific tuning my car.. a few have tried - but haven't been able to find anyone decent.. was going to try out PSI.. i know he's blown enginers - but some other people had some pretty good reports about him and i should be able to screw him down on price cause of the ITC wiring diagram he got from me which I can imagine will be worth $$ to him in the long run..

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...