Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Jeezus you guys can whore!!!

I go do some work for a bit and BAM!! 5 pages!!! :D

Me looking to move either to Northbridge, West Perth, Subi or East Perth in about a month. Sick of the place I'm in.

Have found a place in nthbridge - bit pricey tho at $250. May have Zanda moving in, may go it alone, may get someone in.. so if anyone's looking and they aren't a dick then PM me..

Hey Niz are u and Vspec joined a the hip or what? right after he posts.... BAM :D hehe

On a more serious note: So its another stroke? as longas they catch em quick they are getting good a treating that kind of stuff. my grandma had one a while back and she almost fuly recovered

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
×
×
  • Create New...