Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by Nizmo

ive been caught out *blushes*  

Im the other side of the suburb from Ray - probably could give u the directions himself - my dad is mates with his brother.

I think after what Frank did to Rays car , I don't think there mates atm though:D

Cheers

Ken

Originally posted by Nizmo

yeah i spend too much of my time daydreaming Joe - when i used to catch the bus too and from work *shudder* I quite often miss my stop cos i was too busy off in my own world - i find it pretty hard to concentrate on anything is my problem

hahah true... you do day dream too much...

just tune out the reality, it can be bad especially when you are driving hahahahah :P hey but then again Issac newton spend his childhood day dreaming :)

haha yeah its been long time since ive been to Ray's house - when the injectors were playing up in the ZX - wish i had the many imports just lying around in my backyard ...... guess ive got two - its a start :P

I dont do it often when im driving Joe - mainly when im sick or tired. You caught me on a bad day i think.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...