Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

yeah if a guy leaves them in his room i usually have a read haha my ex used to read my mags :P

Im going to take the Are you hard work or just high maintenance? quizz - finally i will know the truth :P

Originally posted by Sneeza

dark - yeah but it has hell funny stories and those wierd facts.... its like playboy with the "I only read the articles" bullshit

hahaha..

oh well..

yea.. on camp everyone gathered around (including the teachers, 2 female) and talked about sex.. while reading cosmo.. omg.. 4 years of respect built up for those teachers.. GONE in 2 days..

hahahaha

yeah actually im a bit touchy about the subject of being high maintenance - my ex made out that i was the highest maintenance girl in the world (when asked him how he arrived at this conculsion - he said by the way i order my sandwhich - say what?) But ive had other people say totally opposite - i try not to act like a spoilt brat but i guess i do turnon the tanty sometimes.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...