Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Couldnt have said it better myself.

Some ppl wont even meet and greet at cruises and thats not really the crew we want. The early cruises were good cause we would get around 12 cars and they were all regulars. Ken adam32 adamq skyzerr joe gradenko radium myself etc etc

Plus u can trust ppl not to ram u in teh ass which is more then i can say for big cruises where i dont know any1.

Originally posted by Nizmo

yes - cos cops have a lotof experience in organising car cruises :D  

sheesh - such a dumb idea - wasting breath just discussing it!

thanks for the insightful, helpful and positive feedback niz.. very inspiring..

boost & paul - the only reason i'm for the idea is that on bike cruises general info from the cops was very very helpful.. it also helped that we had a few cops in the group as they could tell us in advance where the problem areas were and what to stay away from...

was just suggesting that sort of insight would be useful applied to car cruises..

i'm all for the smaller cruises over the big ones for the reasons boost listed.. rather have a super happy fun small group than a big tailgating angry group.. :D

Yeah, but the SAU cruises, without other clubs are still quite tight-knit:D

Cam, I agree, if we can try and avoid going through the areas like Freo strip etc, then the cops wouldn't stress so much. We don't want to cause trouble.

See'ya:burnout:

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...