Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by macka

Joe have some water..

Remeber ratio

4:1

4 bottles of water to 1 glass of beer :P

Christ !! is that right.

Looks like they had better build a bigger dam with the amount of booze I consume.

Cheers

Ken

Originally posted by Micko

Ken - you walked in just at the right time...

What is the diff between resistor & non-resistor plugs?

Steve told me not to get the resistor ones because they wont be as good. Most people seem to be using resistor plugs though:confused:

I dont think your on the right track there...

Plugs are all resistive....some low and some high??

Macka you ain't see me drink cos you only go to places where I have to drive home.

If I was staying or getting a lift home , well then you would see some......

Micko , unsure about the diff but think you need resistor plugs with electronic ignition.

Doesn't Hendo recommend BCPR7es-11 or something like that

Cheers

Ken

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...