Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

that pic was taken early morning back in feb of when I first had the cooler put in :) Looking at my car sat next to niz's made me see how crap the stock car looks :( I have a set of side skirts and rear pods, which I should get on in the next few weeks, then I might have a look around at a new front bar. I'm not sure about lowering the car though as I have a high kerb to get over on my driveway and the last thing I want to do is scrape a front bar on it. Plus pauls got some 18x9 enkei rims (only 2 though :D ) for my rear then I can wack some 255 rubber on em :)

thank u aidwin - yeah im pretty happy with the way my car looks - apart from my back wing is cracked and my dad did a bodgy job trying to fix it haha. All it needs is so go fast bits haha

yes i did thanks Kyles - can i get back to u a bit later - paul says its alright if i still go down with him so yeah just give me a couple of days to get my head straight and i'll figure out what is best for me to do :) Thank u again tho - thats most generous of u & Troy :D

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...