Jump to content
SAU Community

Recommended Posts

chance it'll be extended Erin?

Mine is to the 30/6 but there are talks maybe til Oct sometime now - my boss still told me not to get to comfy so im taking his advice!!

Talking about not gettting to comfy its my hometime :D

Later all

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Hey rob

hks controllers are a heap of bog

maybe the new ones are better.

I dont think it would matter on the needle valve too much if i laid the solenoid on an angle shaggy.

Also i dont have a duty cycle what i was talking about seems to be an "offset" to sync your reading from your ebc to your boost gauge as they are always going to be different

Spot on mate... I've been doin a bit of reading up on it aswell..

After it was playin up the other night, i pulled apart the solenoid and found a little bit of rubber stuck in the valve, cleaned it out and it runs sh*t hot now.I ended up mounting mine almost sideways in a cooler part of the engine bay.

i dunno guys.. It holds boost nicely, then suddenly drops and almost holds a lower setting.. It's too sudden and neat to be the actuator spring. Rob might be a silly question, but you've unplugged all the factory boost solenoids and crap haven't ya.. try a bleed valve and see what happens.. i would have thought the spring would drop off boost slowly as it struggles to hold it, not just drop it from 13 to 11psi instantly.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...