Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by 33Spec2

i think liz would kill me if i spewed in her car! haha i would kill someone if they spewed in my car

Involved in Rallying as a service crew, on more than one occasion I have had to clean up the Nav side of the car.

It's hard to do when your dry retching yourself..

Cheers

Ken

damn!

if something happens to me then its my own bloody fault - but i rather enjoy life - fatal things can happen in any situation - just look at sept 11 - those people jus tthought they were starting another boring day at work. I just make sure that if im doing anything stupid theres no way i can harm any innocents

Originally posted by Sneeza

I have cleaned spew off my car many a time.... well in my old pulsar hahahah its all part of being a uni student hahaha I retch if someone spits in front of me hahaha

Don't have kids then.

We haven't cos if the nappy had to be changed , it just wouldn't happen...:(

Cheers

Ken

Originally posted by G0DF4Th3R

niz - always wondered if ure avatar was a pic of ureself

Course it is , can't you recognise the blonde hair , the dimple , the mischevious grin.

Yep , that's her...:(

Cheers

Ken

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...