Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by Nizmo

ken its not - i want to go back its more he's destroying himself and now i feel partly to blame that he's gone so downhill! Ive been living in this "he's ok, hes doing fine - someone suceeded wher ei failed bubble" and its just been popped and i feel head phucked.

Why, and have him pull you down to his level as well.

Niz , if you left him there must have been a reason for it so I am sure the reason is still there.

Cheers

Ken

Unfortunately i cant help but blame myself. But he's bought it all upon himself - just hard to see someone that u used to love and part of the reason i left is in the hope they would find help but now he's worse. Bu thats the first time that since we've been apart and ive bumped into him and he's just uped and left - usually he's really pleasant and friendly today he looked like death warmed up.

garlic prawns yum my favourite ..... havent had dinner. Cant be stuffed.

Im not normally one to let people upset me but i think i just care what happens to some people too much - i honestly dont want to see him unhappy ...... i would love to walk away and not care but at the end of the day i do.

haha honestly ..... what did u think Liz? not that u got to see much of him and he didnt smile one bit the whole time - which is a pity he has a really nice smile.

Thanks Bam ya softie :goruphug:

hey cam who was the chick u were with - u seem to have a different one for each week :D

Guest
This topic is now closed to further replies.



  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...