Jump to content
SAU Community

Recommended Posts

phucking sick of working here ...... everyones getting taught something but me .... i dont know whether its cos im a temp or what but all i seem to get is the real shit jobs palmed off to me .... even by people on the same job level as me! I dont get any responsiblity or anyway to prove myself - im just constantly shuffling paper from one end of my desk to another and ive had enough ..... i want a phucking proper challenging job!

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

department of industry and resources ..... admin assit in trade & investment section ...... trust me sounds a lot more glamourous than it is - im basically your average shitkicker!

yourself?

i got a scratchie today .... i never buy scratchies normally - didnt win anything tho :)

haha wow so much money what did u spend it on .... sundae from maccas :D

so if thats not what u want to do ..... what is it you want to do?

Hey Bel :) laptop - my mum is looking at buying one of them :D I borrow works occasionally

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
×
×
  • Create New...