Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

*and for the intermission of all this serious bullshit stuff*

But did you save the world Mel .... did you? i still hear my nuclear weapon ticking away .... the world will be miiiine i tell ya mine ..... BUT first - to the pet store *point upwards with feet apart* to get myself a cat .... for everyone knows a villan has to have a cat!

You can have spiderman ..... he is more spider .... than man :(

Turn to camera and start talking to myself "you will be mine, just you wait n see my pretty, your time is up ...... its my show now

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

don't make me get off my fat arse evillauren! you have forced me to use my precious time to save the world (instead of watching what's in the box and jerry springer) by forcing me you have driven me away. to team up with spiderman (also in negotiations with the power puff girls and elmo)...you will never suceed...neveeeerrrr!..... to the mel mobile! *swish*

i dont like talking to people over the phone ..... i need diagrams to explain ..... i wanna show Mr Policeman my nice scribbles/ works of art in order for him to fully understand the situation!

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...