Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

cool just got this email from Bayley that has your personality by the cars you own ..... unfortunately mine is right :P

Nissan R33 Skyline: Look at what my daddy bought me. It's even got an original Nismo sticker!

Ford laser - I dont have a choice :P

Nissan 300ZX I have yet to complete my divorce proceedings < hope not!

yeah but i know the dick :( he's just set up a fencing business .... hehe wont take long for dad to take him out :uh-huh: parents are good 4 something!

Lee: Holden Sandman I saw Mad Max 367 times

Holden Berlina I am a very good Amway salesperson

Holden Statesman I am a pimp

Holden Statesman HSV I have a kilo of cocaine in my wheel well

Holden Commodore GTS-R I'm in a mid life crisis and reckon Johnson is a slow old codger

Holden Gemini I delivered pizza for four years to get this car

Holden VT Commodore (Pursuit Rims) I enjoy having people slow to 60kph when I pull up behind them

2002 Monaro: I have nfi about cars, but all my rev head mates think I am a hero

Sorry nothing with just plain boomodore!! We'll just say Commodore: I have a wardrobe full of flannellette and a fridge full of VB ... i think im the burnout king! :P

Guest
This topic is now closed to further replies.



  • Latest Posts

    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
    • Yes then it will turn on but I want the car features to work  
    • My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • What about if you just give it direct 12v and earth?
×
×
  • Create New...