Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by GTS-t VSPEC

I try not to include whore in my job description, incase they want me to do sexual favours:p

See'ya:burnout:

nah i no longer work for car dealerships - dont get asked for those favours ianymore haha

anyway whats this faster than niz business haha - like im a challenge to beat ! hehe :D

but i cant prove your wrong paul your too quick! Maybe if we can take the engine out and you push your car up the track then i may have a slight chance of winning haha tempted to throw in another macka joke but i think ive given him enough already haha.

yummy yummy sandwhich!

saw so many 180's going to get lunch today - invasion i tell ya!

hmmm what other bits of uninteresting time wasting bullcrap can i share with you........ give me a couple of moments i will think of something. :D

troy who u order ur ebc from?

howdy dudes,

how r ya all today? the weathers gettin a tad dodgy eh? come back summmmmmmmmmmmmmmmmmmmmmmmmmmmmmer

i am very very bored, no gym today either, feel like a extra fat slob!

adrian :D

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...