Jump to content
SAU Community

Recommended Posts

Guys,

I have a 33 with a FMIC, 3 1/2 exhaust, POD, Apexi Power FC

I would like to know approx settings people are using in their Power FC as mine is running bad atm... At about 4-5grand under full lead will start surging and exhaust popping noise.

Only running 8 psi atm...

Settings under:

Ign Map

Inj Map

AirFlow

Injector

Boost

Acceler.

Ign/Inj

Cranking

Wtr Temp

Rev/Idle

Now i know these may not work the same as your car thats been tuned, but hopefully will run better than the current settings..

Any help would be great, thanks...

I am going to get it tuned in just under a month, but till then would like to know some settings...

Link to comment
https://www.sau.com.au/forums/topic/88663-power-fc-settings/
Share on other sites

ok, well, when I was in the same boat as you, I ran 11psi and the car ran fine. Maybe the extra boost helped the car lean out a little and run better.

I had 0 knock, so I'd suggest gapping your plugs, and gonig for a drive and watching your knock levels. If it starts knocking, wind the bost back 1 psi slowly till it stops or is under 20% knock.

Be very careful thought, if it knocks, BACK OFF the f**king throttle. Adjust the boost right away.

But the best thing, get it to a tuner asap. I did, and now I am running 210rwkw, as opposed to 140rwkw with the standard pfc maps.

Standard pfc maps at 13psi gave 160rwkw. Not bad I say.

if your getting a bad run or surge then watch the knock and turn the boost down till you get it tuned or at least the afr's checked. you shouldnt need to adjust any of those settings as the defaults are fine for most cars

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...