Jump to content
SAU Community

Recommended Posts

I did my non type m to type m brake upgrade over the weekend as I got some 4 spotters for free of my boss, however I didnt get the type m rotors.

Everthing went on fine I had a little trouble bleeding the brakes but every thing seems fine now the brakes seemed really firm until I turned the car on and went for a blat. The brakes have to be almost on the floor before there is any retardation I assumed that the smaller stock rotors wouldnt be a problem as it would just be similar to running worn brake pads?

I also used the pads that were with the 4 spotters rather than buying new ones as I wasnt planning on doing the upgrade till I had the funds for the set of types front rear and new pads.

1. Should I buy a set of new pads and see how they go (dont really want to do this as it may only slight help but not fix the problem)

2. As the pedal feels very firm when you pump it up, have I not bleed the brakes correctly? (I printed of the s14 manual and followed it after searching for hours on end)

3. Should I try and get some type M rotors as the non ones are to thin?

4. take it to a brake place and confuse them with the whole type m non type thing and end up spending heaps of cash replacing brake master cylinders, getting the 4 spotters rebuilt etc because they dont know what there doing

Link to comment
https://www.sau.com.au/forums/topic/89701-type-m-brake-upgrade-probs/
Share on other sites

what rotors are you using?

you cant use non turbo rotors on Turbo 4 spot calipers as the rotors are to thin , change to the r32 GTST rotors as they are thicker and they are the direct fit for that caliper....

Edited by urbanoperations
thanks dude but Ive got turbo non type m rotors Im going to change them over now anyway

You might also want to check which size your master cylinder is.. it's stamped on the side.. gts-t is 15/16

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Kinkstah, no, coilovers aren't illegal, especially as a bolt straight in. The illegal part will be if they're altering suspension geometry beyond factory limits, or the ride height is not legal.   Sounds like the blue slipper just didn't want to deal with any later possibility of mods appearing on the car.
    • The problem has always been that coilovers are able to be adjusted, almost at any time, to be too low. Most people who ever get/got defected for/with coilovers were actually afoul of the minimum ride height rule. So the interpretation by cops/inspectors was always that it is pointless to allow numpty to raise his coilovers and get the car inspected/cleared, then just drop them back down again as soon as they get around the corner from the inspection station.  This led to the interpretation that they were illegal unless rendered such that they can't be adjusted (ie, collars welded to the body, that sort of thing). That may or may not have ever actually been the official line, but I'm pretty sure it's not considered to be a solution these days. Coilovers themselves fall under clause 3.2 b of that manual, because they are an "installation of a variable ride height system" and they don't fit the exclusions in that clause (which point to air springs and other pneumatic adjusters). So, as per previous statements, they require engineering cert to be legal on the road. Once you have such cert, provided you do not adjust them outside the height range covered by the cert, you are OK. Without, you have an unroadworthy vehicle.
    • Here E10 is the cheapest fuel. And general advice is to not use it unless you hate your car. From what I remember it clogs up stuff in the fuel system or injectors?  With US/Canada being E10 across the board, does that mean that all fuel there is terrible?
    • Sorry, are coilovers ACTUALLY ILLEGAL in NSW? They aren't in Vic, as long as they retain 70% of stock travel and the car is above 100mm off the ground. Does NSW actually have a law making coilovers actually illegal? RWC/Blue Slip/Engineering people not knowing the actual f**king laws boils my blood. Demand them to point to the documentation that states a coilover is illegal. (it may exist in NSW ) Edit: I checked. They aren't. https://www.nsw.gov.au/sites/default/files/2021-02/RMS-infosheet-light-vehicle-modifications-manual-suspension-and-ride-height.pdf
×
×
  • Create New...