Jump to content
SAU Community

Recommended Posts

  • Replies 58
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I had 5 runs and left just as the burnouts started at 9. Yeh should be a fairly low 12 with some proper setting up. .

One of my runs - Had a great start with a 1.70 60foot (lowest for the night), hit 2nd gear pulling damm hard and the bloody ashtray fold out thing in front of the gear stick comes crashing out and blocking me going into 3rd gear!! Damm thing was full of loose change so it ended sending it all over the floor of the car haha..Cost me a good run!!

The ashtray ended up in the back seat somewhere..couldn't believe it when happened grrr

The 12.5 was at a 1.7 60 ft 1.79 to be exact..did the 1.70 on the ashtray affected run :)

Had a few close runs with MADGTR 2nite, he did a best of 12.4 i think.

Well done :)

Interesting, the first (and only time) i went to the drags with my stock turbos, making about 250rwkw i ran 12.4@111mph... there was more in it but the strip was crap for traction that day i was told by other regulars. Axle tramping all the way through 1st and 2nd sucks.

Do you feel there is anymore MPH in your current setup?

The R32 is also lighter so i would of expected it to be a little quicker than my R33.

Had a run out at WSID tonight..

12.5 at 112mph :D with a 1.7 60 foot

Perfect 60 ft , i only wish i could do that in mine but then again i have an extra 100 odd kg on me !

Good to see MADGTR having a go , if i knew i would have beeing there to match race him , as we have the same set up in our cars .

What was your trap speed Paul ?

The track would have been very average last night. Their hasn't been any racing on the track for about 10-14 days due to bad weather. It's also been about 3-4 days since I last seen the sun so the track temp would have been very low.

The run that you missed 3rd I remember my reaction from the launch (it looked way faster than the other runs) thinking "this has gotta be a low 12 for sure" then you missed 3rd :D

Their is certainly a 12.0-12.2 in the car, just a matter of time.

Good nite, pity about the weather (not many cars).

Edited by benm

becuase an r32 gtr intercooler can run about .9-1 bar efficently before it starts to restrict the turbos(run out of flow capacity). an r34 gtr cooler flows a bit better from memory its about 1.2 bar

Edited by mr 32

I think it should be a tad bit higher with a good driver (no offense), quick gear changes, and revving it out all the way to 8 :P

Hell wrxhoon did 118mph in his 34 gtr with stsandard mods with gtss. the heads a bit better than it is on the 32 and 33 so hes got a bit more power .....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...