Jump to content
SAU Community

Recommended Posts

ive been down to the drifts in nanko but i cant find anywhere that theres some 0-400 happening.everyone ive asked tells me to go to chiko which i have at various times but havent seen anything or even anywhere that looks like itd be good for 0 - 400.any help would be greatly appreciated.

Link to comment
https://www.sau.com.au/forums/topic/91988-street-racing-in-osaka/
Share on other sites

Good point, Ive been in Osaka for nearly 2 years and havent seen any drags... mostly due to the fact I couldnt care less about it though :P

with my car off the road for a while thanks to shakken it might be time to go have a look though. If you find out where and when let me know.

If its anything like the drifting though it may be a bit dead at the moment. The street racers here seem to be a little soft when it comes to cops and are easily scared off.

^^^ yep, definately not like the heydays back 5 or 6 years ago. The drags were out near a huge Kuroneko Yamato depot... I know thats pretty vague, but once you're out there just follow the heavily modded RX7s to where they're going ;)

Savalas will probably have more detailed directions?

Depends what you call dead. Up till summer last year everyone was going to the same place on Friday/Saturday night so you would have a huge amount of cars at the one place. Now its split over 5-6 places.

So for the spectator I guess its not as good. But for someone who is participating it doesnt really make much difference, an actual bonus is that cops are less likely to break up a group of 10 cars Vs a group of 50-100.

shakken is like an aussie roadworthy test every 2 years... (my car is currently off the road cause of this RRRrr) and costs a furken fortune!!

The cops are supposed to be cracking down on illegal cars lately but its nothing like Australia. IF you are unlucky enough to actually be stopped 90% of the time you are let off with a warning. Very occasionally they will write all of the defectable items down on a form and you have to repair/replace these items and present the car to the designated cop shop.

Speeding is far more lenient here and 10-15kph is pretty much ok, atleast in Osaka anyway. The speed cameras are as big as a house and mounted above the road so you can see them about 2kms away. They dont even go off unless you are doing about 40-50kph over! LOL

Drink driving is alot more harsh with big fines, about $3500 AUD, and a limit of 0.01% BAC or something (basically you are not allowed to drink and drive).

Edited by Streeter
Ive been drifting my car for 2 years...  the latest thing Ive been working on is touching gutters on entries so you dont wanna know what the car looks like now  :lol:

I remember that night... myself and a friend were there for all of 20 minutes and then disaster struck... surely you could get 9 -10K for your S13 in AU Jesse? :D;) ;) hehe

monk: I'm on temporary hiatus until I get my #$@%&$#@ing computer out of customs... and my cars... and my furnature... and my...

yeah 9-10k (maybe for an unregistered beat up Qs with an engine swap)minus shipping it to aus, getting someone to sell it for me, how ever much deregistering is here plus who knows what other hidden costs.

Sounds like Id be lucky to come away with 5-6k change in which case Id be hard pressed to get a better car than I already have. Not to mention down time of having no car and all the potential f**kups along the way... I think Im just gonna take it up the arse and get another 2 years shakken on it. :D

ive been down to the drifts in nanko but i cant find anywhere that theres some 0-400 happening.everyone ive asked tells me to go to chiko which i have at various times but havent seen anything or even anywhere that looks like itd be good for 0 - 400.any help would be greatly appreciated.

Chiko has been dead for years. Used to be as many people out watching the drags as were watching the drift. The road that they used was frequented by a lot of big trucks. I think the trucking companies and drivers got too sick of it all and put some pressure on the Government to do something. At first they made ripple strips all the way down, after that didnt help they put an island and barriers that ended up in a bottle neck, then they made the whole area off limits after 10pm. It then all dried up. I remember I was out there once and the cops blocked off both exits will buses and gave everyone a ticket, except me !! :-) baka gaijin, nihongo wakarenai !!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...