Jump to content
SAU Community

Recommended Posts

I went to dragstrip last night and managed dissapointing time of 13.8s, 109mph (175km/h)...car is r33 with bigger turbo (its T-57) making 347hp atw ON 15psi, and i expected at least low 13s...traction was shit 60 foot 2.478 sec, with shit trampio tyres at the back 18 inches 265 wide, tyre pressure at 40psi (stupid me checked today tyre pressure)...what do you reckon the car should do with this mph, and what launch methods u using, i managed best 60ft without much throttle at take off and whenever i upped the revs i couldnt do better time than 2.6 60foot...i noticed as well that gear stick was sticky on second run, i needed to push really hard few times to get it in third gear, still beat wrx hehe...what could the reason be? i suspect when car was brought here from japan while compliancing all the fluids have been changed except gearbox oil so it could be too old?

Link to comment
https://www.sau.com.au/forums/topic/93500-dissapointing-quarter-mile/
Share on other sites

i have 225rwkw and got a 13.5 at 109mph... 60 foot 2.3 on 235/45/17

then the next week went back (same set up) and managed 13.1 at 110mph

then went back and got 12.71 at 111mph 60 foot of 1.93 on the same tyres...

just go back and practice...

by the way i launch at 6 grand

hope that helps

i have 225rwkw and got a 13.5 at 109mph... 60 foot 2.3 on 235/45/17

then the next week went back (same set up) and managed 13.1 at 110mph

then went back and got 12.71 at 111mph 60 foot of 1.93 on the same tyres...

just go back and practice...

by the way i launch at 6 grand

hope that helps

is that a 6000 dump or u let it ride a little

is that a 6000 dump or u let it ride a little

i ride it a little. best way to explain would be that i let the clutch go in one fluid motion over a period of about a second or a bit less.

don't hit the limiter it will die in the ass before you grab the next gear... your MPH indicates a mid to high 12 sec pass if you can get the 60ft time down to 2 flat...

I suspect your suspension setup to be at fault... common errors for drag are too stiff a rear suspension and too much neg camber at the rear as the car has been lowered? modern IRS cars don't like to be lowered or you will just fry the insides of your tyres... which is even worse with wide tyres... get some camber adjustment bushes should help get the beast off the line

i have a feeling if i had 50hp less i would have done better time

i have 225rwkw and got a 13.5 at 109mph... 60 foot 2.3 on 235/45/17

then the next week went back (same set up) and managed 13.1 at 110mph

then went back and got 12.71 at 111mph 60 foot of 1.93 on the same tyres...

just go back and practice...

by the way i launch at 6 grand

hope that helps

what revs is rev limiter at

don't hit the limiter it will die in the ass before you grab the next gear... your MPH indicates a mid to high 12 sec pass if you can get the 60ft time down to 2 flat...

I suspect your suspension setup to be at fault... common errors for drag are too stiff a rear suspension and too much neg camber at the rear as the car has been lowered? modern IRS cars don't like to be lowered or you will just fry the insides of your tyres... which is even worse with wide tyres... get some camber adjustment bushes should help get the beast off the line

suspension does feel stiff, its tein not adjustable suspension, no camber kit

don't hit the limiter it will die in the ass before you grab the next gear... your MPH indicates a mid to high 12 sec pass if you can get the 60ft time down to 2 flat...

I suspect your suspension setup to be at fault... common errors for drag are too stiff a rear suspension and too much neg camber at the rear as the car has been lowered? modern IRS cars don't like to be lowered or you will just fry the insides of your tyres... which is even worse with wide tyres... get some camber adjustment bushes should help get the beast off the line

I went to dragstrip last night and managed dissapointing time of 13.8s, 109mph (175km/h)...car is r33 with bigger turbo (its T-57) making 347hp atw ON 15psi, and i expected at least low 13s...traction was shit 60 foot 2.478 sec, with shit trampio tyres at the back 18 inches 265 wide, tyre pressure at 40psi (stupid me checked today tyre pressure)...what do you reckon the car should do with this mph, and what launch methods u using, i managed best 60ft without much throttle at take off and whenever i upped the revs i couldnt do better time than 2.6 60foot...i noticed as well that gear stick was sticky on second run, i needed to push really hard few times to get it in third gear, still beat wrx hehe...what could the reason be? i suspect when car was brought here from japan while compliancing all the fluids have been changed except gearbox oil so it could be too old?

it's all about the first 60 foot. 2.5 is way too high to be able to run a low13/high12. i am pretty sure it's just a practice thing. and lower your pressures to about 24 psi. that will help a shiteload :(

Dump the 18's get some sticky street tyres on some 16's,select correct tyre pressures,change over your susp for some 90/10 's pedders,take the spare and any thing else loose out of the car,i would lightly slip the clutch on initial drop, short change into second,dont drive to limiter in 2nd then give it all you have got in 3rd and hang on,drop into 4th if you need it.The biggest mistake every one makes is using too much 1st and 2nd gear these only result in excessive wheelspin- hence your slow 60ft times,3rd gear is the one that does the driving and you must get up into it as soon as posible!

Anyhow good luck with your future racing (remember is not the out right hp but the way in which you hook up! )

Regards,

SKYLINE (Kym)... B)

Edited by skyline

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • It's funny, as Ive seen plenty of people use them in cheap builds on YT. And they actually go okay, even though a lot of other maxspeedingrods stuff is terrible. Those turbos seem reliable enough, the only part being, a good quality turbo that is "identical" to it, will out perform it day in and day out. In both a lower boost threshold, and the ability to flow more air at the same boost pressure. As a cheap cheap replacement, not a terrible choice. For cheap and shouldn't blow in a day, not terrible (like other eBay/Temu turbos) for low cost and still decent performance, that's where the question comes in to play from the results I've seen. I'd actually find it hilarious to buy one, and strap it to a paddock basher or some other cheap as POS originally NA car, and send it to the moon!
    • The maxpeedingrods turbo is cheap and bolts on to stock parts. I think you just need a bigger silicone coupler for the intake. Its a cheap china turbo, but it's been running on mine for almost 3 years at 16-19 psi.
    • What do they look like right after you've tried to start it with everything connected? Also post photos of what they actually look like.
×
×
  • Create New...