232hp Is This Right For My Mods In Auto R32

[AntonRx7]

i think its just the rev limiter cause it just sorta doesn't really go or change gear for a little while after it happens and it doesn't always happen just sometimes. My speed sensor on my gearbox is a bit dodgey i think so may be a bit of a problem with that. Ill make sure its rev limiters tnite when i drive it again

[BHDave]

Mine was just a single 1 piece dump/front pipe with a 3 inch catco cat and 80mm cat back with 2 mufflers.

The wastegate couldn't be leaking after getting a knock in the post could it?

[AntonRx7]

have you seen the boost line on the graph. it seems to be holding the boost so i don't think it would be leaking then would it

[BHDave]

good point, i should pay more attention.

When you run less boost does it come on boost earlier? I'm just thinking about the stock rubber intake pipe sucking closed. Also, what sort of filter are you running?

[AntonRx7]

i dono have not tried it will give it a shot later,although i don't want to loose the boost setting atm as can be a bit of amission to get it set back right. i would not have though it would be sucking closed. its a Apexi pod filter also i have a right angle bend for the pod so it sits a bit further away from the engine as is closer to the outside air intake but i dont think this would matter either

thats the filter i have http://www.modyourcar.com.au/product_info....roducts_id=2604

[Miller the hoon]

I think it is that

4 of the best Tuners in perth told me it was

A) plug gaps

B) rev limeter

C) fuel cut

I used to have a blead valve and could not adjust boost properly but now i can adjust ot .3 of a psi

So C) was the correct 1 but only after they checked my gaps and tryed to run more boost looking for hp

i tune it my self with the help of turbo smart

if we have a cruz i will show you wat i mean

changed my whole out look on moding my auto

james

[BHDave]

The pod shouldn't cause problems. They are one of the best flowing on the market. The pipes do suck in if they are a bit old and you are running a bit of boost, though it would have been spotted on the dyno i'd expect

[AntonRx7]

yeah i would think they would see it on the dyno. Is there any way i can check this?

Miller are you saying it is the boostcontroler that was your problem, cause mine is only a cheap one. (the 22$ one on this site).

[Miller the hoon]

Was not boost controler more the boost it self

i found the eboost2 very easy to work very precice

soo i could fine tune the controler and no dyno needed 4 that

just turn off the car start it and change boost settings from the cabin

and it a very acuate boost gauge as well some thing i through was a waste of time

how wrong i was

i have tuned mine so well i flat stick it and no more pops and more power cause engine is firing and ecu can handle it

best $915 i spent

james

[AntonRx7]

don't think ill spend that much on a boost controler. If its hitting the revlimiter before changed do you think the shift kit would help solve this

[Miller the hoon]

Did it hit the rev limiter before the tune or before you modded it up

before i had it i would not have spent that much so glad i did

the best mod i have

james

[AntonRx7]

yeah it did occasionally just now it takes longer to shift. It doesn't always do it just sometimes

Edited November 22, 2005 by AntonRx7

[Skyline-man]

Im getting 220hp with standard ECU, and a exhaust.. everything else stock other then a air filter...

with shit plugs and 95ron premium..

[Skyline-man]

Im getting 220hp with standard ECU, and a exhaust.. everything else stock other then a air filter...

with shit plugs and 95ron premium..

[predator2]

edit: don't worry

Edited November 22, 2005 by predator2

[Miller the hoon]

Wat buttons do you have

ie power and overdrive

is the power on

the gear box should pull more kw than that and is the 32 a learning computer

james

[AntonRx7]

yeah depends a bit on the dyno though as well some read pritty high. I have never heard of hyperdrive reading high seems they are quiet acurate. Do you have a manaul and rb25 though?

I am going to Mayhems thursday he is gona have a bit of a look he doesn't seem to think its right either

I have power and hold button on the auto umnm i think the computer learns

Edited November 22, 2005 by AntonRx7

[Cubes]

Skyline-man.

Anton's car is an Auto R32 RB20DET. Totally different kettle of fish to the rb25det.

Edited November 22, 2005 by Cubes

[Miller the hoon]

If it learns has it gone to far past the gear change learning thing

ecu reset will that help i wonder

it is faster when it does not pop isint it?

james

[AntonRx7]

yeah cause it takes a bit of time for it to change gears sometimes so would make it a bit slower. Boost seems to fluctuate up and down at the end of the rev range a bit as well as i have recorded it on my defi gauge dono if that is just from bouncing of the limiter. I will see if it does it tnite as i am not 100% sure if its is the limit. Either way still has got nothin to do with why its low on hp