Jump to content
SAU Community

Recommended Posts

Hey all,

THIS FRI 9th DEC Small Cruise starting 9pm, for a 930ish start...

only a short 1 no long/getting lost routes.

PM "VANGE" FOR DETAILS

There have been several sau members from sa that are interested in this mini cruze, so come along n Have a bit of a chit chat face to face n check out each others rides.

Kind Regards,

Shorty

Edited by shorty_01
Link to comment
https://www.sau.com.au/forums/topic/97507-mini-cruze-this-week-fri-sat-sun/
Share on other sites

  • Replies 88
  • Created
  • Last Reply

Top Posters In This Topic

sorry guys, I have (provisionally pending final finance) sold my S15 tonight, and the R34 isn't quite on the road yet. Have fun and we'll catch up in Jan for a mega Victor Harbor cruise.

sorry guys, I have (provisionally pending final finance) sold my S15 tonight, and the R34 isn't quite on the road yet. Have fun and we'll catch up in Jan for a mega Victor Harbor cruise.

congrat mate

hope to see the 34 on the road soon.

Sorry I cant come either. Both of my toys are in the workshops :P

Should be able to make it next Friday....if this cruise doesn't go ahead.

Edited by 9krpm

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...