Jump to content
SAU Community

Recommended Posts

Hi my names Mark,

Just yesterday I had experienced my car having boosting problems. It would rev to 3,500rpm - 4,000rpm and usually you would feel the boost coming on strong. Yesterday it was probably boosting half as much as it should and I am only running the standard 7psi. The boost gauge seemed to be working ok. Although the heat yesterday would have played a part to it as I do not have a front mount cooler.

I waited until later in the nite although it was still a little warm but much cooler than during the day and it still wasn't boosting like it had been previously.

I am lost for ideas, what do you guys think of the problem?

Thanks Mark

Link to comment
https://www.sau.com.au/forums/topic/9847-boost-problems/
Share on other sites

Hmmm I think I am experiencing a similar problem... On recently I have noticed that when I put my foot down and the car starts to boost it used to just lauch so to speak, now I can hear what appears to be extra large sucking sounds for a short period then the power jumps in. I don't know if I am being paranoid or not but my boost guage ( standard in dash ) doesnt really seem to begoing as high either..

Is it possible I have a hole in a hose or popped a pipe off or something simple???

Link to comment
https://www.sau.com.au/forums/topic/9847-boost-problems/#findComment-153412
Share on other sites

The other thing I have noticed also is that my oil gauge used to sit around the 4 mark pretty constantly, now it seems to vary quite often ( under acceleration and such ) between 2 and 6?

I have checked my oil and its not low or anything like that....

Link to comment
https://www.sau.com.au/forums/topic/9847-boost-problems/#findComment-154418
Share on other sites

MrGTST,

It sounds like a boost leak to me, when you in the drive way pull the accelerator cable and listen for unusual noises, should highlight where the leak is occuring.

I think the oil gauge measures viscosity, therefore it should be higher when cold, and lower when hot.

See'ya:burnout:

Link to comment
https://www.sau.com.au/forums/topic/9847-boost-problems/#findComment-154698
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
    • Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
×
×
  • Create New...