ColdFusion

Got some stuff to get rid of. Need monies. R33/R32 GTR Apexi Power FC with hand controller. Specific model is R33 GTR version. Comes boxed with printed manual, it may have an RB20 map loaded, not sure. $750ono Z32 Bosch/JECS AFM with wiring plug, used. $200ono RB26 GTR Injectors. Yellow top 444cc/440cc. Cleaned with new seals and new pintle caps. $300ono RB26 GTR Injectors. Yellow top 444cc/440cc. Not cleaned but in ok condition with all pintle caps. $150ono 2x GTR resistor packs. $80ono each Pickup is near Armadale after hours or Forrestfield during business hours, 0412 939 86zero

Looking for an R32 GTR rear sway bar please. Thanks.

Does the r32 wiper bottle come with working motors?

Yes just the eyelids please

I just realised I haven't received a PM for my order. Is that right or..?

Can you please remove the vented headlight from my order please. So should just be the eyelids. Thanks. Do you actually have a photo of what the eyelids look like for R32?

Please add R32 wind deflectors to my order. Do you have the dash twin gauge pod available? Plans changed :S Thanks.

Looking for a push type GTR box in good condition please. Cheers, Aaron.

Ahhhh damn hey. Should've contacted you earlier i guess haha.

Hey man. will take the box depending on which type it is. Can you confirm if the box is push or pull please? my number if u want to txt is 04129398six zero Thanks.

Need a working cigarette lighter socket to fit R32. Not actually sure if other models are all the same type. Or if someone knows where I can buy a new one. Trying to avoid Nissan Genuine, but looks like I may have to go down that path. Cheers.

Need a working cigarette lighter socket to fit R32. Not actually sure if other models are all the same type. Or if someone knows where I can buy a new one. Trying to avoid Nissan Genuine, but looks like I may have to go down that path. Cheers.

Please include R32 FRP eyelids for my order. May have missed my first post. Thanks!

How's the 32r box?

Gonna have to change my order as selling the coupe. Any idea if the wind deflectors will fit the sedan r32 roof line? If not or unsure then will have to remove them. Will add a headlight intake though.

How much is one delivered? Trying to justify the extra cost versus just getting a kompact :S

Do the Nissan dual port BOV's have a blanking plug to block off the trumpet side? It appears they also have adjustable spring hardness by rotating the top, is that correct?

* R32 GTS/GTST/GTR wind deflectors - $130 *R32 GTR/GTST eye lids - $60 Would like to order these two please

Mine takes ages to hit temp even while driving. Like i'm talking a good 15mins+. I think the thermostat may need replacing. TBH, I usually warm the engine up to about 40-50 degrees with some throttle blips every couple mins before taking off. Take it easy, like no positive boost and <3000rpm, until oil pressure drops so i know oil is up to temp.

With warming up the engine. I would say to let it sit for a minute or two after startup so oil pressure builds, coolant can circulate, etc. Like not driving it immediately after the engine starts. Oil I would say a decent 10W-40 is fine. Nothing super cheap, but you don't have to go super expensive either. Used Nulon Full Synthetic10W-40 previously and just put in Penrite 10 Tenths 10w-40, Penrite is not giving any lifter noise on startup whereas had some noise for a few seconds with the Nulon. Slightly thicker if the engine is older/using a lot of oil or used for track.

No worries. Cheers.

Got front corner indicators?

Need another pair of indicators in good condition with all tabs and locators intact. My drivers side one just snapped the top screw one off and already lost all the locators so I had to tape it back in! Prefer the OEM clear type with the little bulging bit in orange. That's what it's got at the moment. Otherwise let me know what type you have if you have a set to suit R32. SOR preferred. Thanks.

Tried a spare z32 AFM that I had and no change so next options are ignitor and CAS. Coils are pretty much brand new nissan items about 5000k's ago so doubt it will be those. Any other help appreciated.

Pulled out the plugs today and they are all black and smell like fuel (I haven't really smelt plugs before so I don't know if that's how they actually smell lol). Third cylinder plug had some fuel on it as well. If I remember rightly the last time I changed the plugs they were indicating normal combustion so I think the problem may be sensor related (CAS or AFM?) as the issue seems like it is across all cylinders not just one. More so on cylinder 3.