Jump to content
SAU Community

Recommended Posts

hey dudez

got a problem with my r32 gtst

yesterday at about lunch time, i had driven it for about an hour, just normal driving.

didnt drive it until about 9:30 pm. goto start up and it idles at about 1500rpm

goto drive it, it wont rev above 2500rpm, and when it hits 2500rpm, its like it hits the limiter, or like a fuel cut...but when i put my foot on the clutch it will rev, and the problem seemed to go away and i could drive home

played around with it for 20 mins and it seemed to be ok after i put my foot on the clutch and revved it.

drove home on the freeway and everything was fine until i put my foot down in 5th to overtake someone and it just coughed and spluttered and it was ok then i tried again and it just died in the arse and stopped, but it didnt stall.......

pulled over and revved it again, and everthing was ok, it would drive normally and wouldnt splutter or struggle

it did the problem again as i got off the freeway near my house.

now i have to drive my 31 again...it just isnt the same....

any help would be appreciated

cheers

Link to comment
https://www.sau.com.au/forums/topic/100394-idle-problemshelp/
Share on other sites

hey dudez

got a problem with my r32 gtst

yesterday at about lunch time, i had driven it for about an hour, just normal driving.

didnt drive it until about 9:30 pm. goto start up and it idles at about 1500rpm

goto drive it, it wont rev above 2500rpm, and when it hits 2500rpm, its like it hits the limiter, or like a fuel cut...but when i put my foot on the clutch it will rev, and the problem seemed to go away and i could drive home

played around with it for 20 mins and it seemed to be ok after i put my foot on the clutch and revved it.

drove home on the freeway and everything was fine until i put my foot down in 5th to overtake someone and it just coughed and spluttered and it was ok then i tried again and it just died in the arse and stopped, but it didnt stall.......

pulled over and revved it again, and everthing was ok, it would drive normally and wouldnt splutter or struggle

it did the problem again as i got off the freeway near my house.

now i have to drive my 31 again...it just isnt the same....

any help would be appreciated

cheers

no one can help me???? im desperate to get it working.....

I had sorta problems like that with my GTR when i first got it. Ended up being a f**ked airflow metre. Sounds like yours is going in and out of being f**ked, like mine would, i think its age and heat. Unplug your airflow metre, and rev it, it should hit rev limiter at 2500 cause its in a safe mode. Might not be the problem, but it just sounds like it, also check your o2 sensor, it can cause problems too, just if your airflow metre is out, would be a good idea to check or replace your o2 sensor. Hope this can maybe help

Cheers

ok...pulled the afm out, found only one screw holding the plug in....put three more in.

plugged everything back together, still not revving over 2500rpm

pulled apart again....checked all the cooler pipes etc...couldnt see and split hoses, but couldnt see the pipes that actually go into the cooler..maybe they are split or loose there.....

also found that my rear muffler is totally f*kd....all the internals spat out....could this be the problem also???

i midas well change the exhaust but dont know what size or wateva....3" turbo back with hi-flow cat? how big of a muffler

cheers guys.....

  • 2 weeks later...
ok...pulled the afm out, found only one screw holding the plug in....put three more in.

plugged everything back together, still not revving over 2500rpm

pulled apart again....checked all the cooler pipes etc...couldnt see and split hoses, but couldnt see the pipes that actually go into the cooler..maybe they are split or loose there.....

also found that my rear muffler is totally f*kd....all the internals spat out....could this be the problem also???

i midas well change the exhaust but dont know what size or wateva....3" turbo back with hi-flow cat? how big of a muffler

cheers guys.....

No revs above 2500RPM = bad AFM.

Yeah, if the AFM is stuffed, it will not rev over 2500rpm (cuts fuel).

Plus it will be running limp home maps which are really rich, because it can't detect actual airflow due to the afm not working, so it will run like a bag of shit.

A quick check that will confirm this 100% is running the diagnostic mode to show fault codes on the engine warning light.

Edited by RB30-POWER
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
    • @Stringycheese  Have you only gone to the one blue slip workshop?  There will be a heap of them where ever you live, good odds that the next place you go to will pass the car.  Unfortunately (or fortunately?) every blue slip / engineering workshop will be different and will be happy passing or failing different things - despite working from the same set of rules. It's kinda like 2 lawyers arguing over a piece of legislation, each saying their interpretation is correct. Might seem strange that this happens when it comes to getting a modified car passed, but this is very much a thing. A big part of the game is finding an engineer / workshop that is on the same page as you.
    • Bah. I daily mine. ~60km per work day, 10-12 thousand km per year. What's the point of having a dirty old Datto and leaving it in the shed. It needs to be driven and enjoyed while the govco allows us to do so. It will only be a few years before we're forbidden to even start up internal combustion engines.
    • Judging by that spring perch and the normal looking spring on it - not a coilover. Well.... it is a coilover, just a stock format coilover, rather than what everyone calls a coilover.
    • Yes it is. We get stock from Nismo directly. I'm happy to take photos/video of it as proof before I ship it with timestamps or whathaveyou.
×
×
  • Create New...