Jump to content
SAU Community

Problem With My 'line!

Rhinorebel

By Rhinorebel,
in Queensland

 Share

Recommended Posts

Rhinorebel Grand Master

Rhinorebel

Posted
Posted

OK, I need to draw on the collective experience on here! Put my car on a dyno this morning to try and diagnose a miss high in the revs. Anyway, the problem is that now the back of the car vibrates and almost bounces at speed. It was suggested at Chilleh tonight that the CV joints might be the culprit, but there is no vibration through the gearstick or steering wheel. All seat of the pants big-time vibration!

Could the dyno have spun the tyres and put out the balance so much as to cause the massive vibration??

Any suggestions are appreciated.

Dave

Link to comment
https://www.sau.com.au/forums/topic/104922-problem-with-my-line/
Share on other sites
Rhinorebel Grand Master

Rhinorebel

Posted
  • Author
Posted

And the prize goes too................

No one!! Turns out one of the tyres was about to pop!! Being some cheap shite from assbang indonesia, they couldn't take our Aussie heat and there were 6 bulges on the inside of the tyre wall all about 4 cm's wide. So, 2 new tyres on the back and we will keep an eye on the front ones. Got some decent tyres this time, Firestone Firehawks. $500 for the two fitted and balanced so not too bad.

Have kept the old tyres as I may take them back as they were only 5 months old.

Squizz Grand Master

Squizz

Posted
Posted
And the prize goes too................

No one!! Turns out one of the tyres was about to pop!! Being some cheap shite from assbang indonesia, they couldn't take our Aussie heat and there were 6 bulges on the inside of the tyre wall all about 4 cm's wide. So, 2 new tyres on the back and we will keep an eye on the front ones. Got some decent tyres this time, Firestone Firehawks. $500 for the two fitted and balanced so not too bad.

Have kept the old tyres as I may take them back as they were only 5 months old.

kwal-it-tee

85URK Grand Master

85URK

Posted
Posted
And the prize goes too................

No one!! Turns out one of the tyres was about to pop!! Being some cheap shite from assbang indonesia, they couldn't take our Aussie heat and there were 6 bulges on the inside of the tyre wall all about 4 cm's wide. So, 2 new tyres on the back and we will keep an eye on the front ones. Got some decent tyres this time, Firestone Firehawks. $500 for the two fitted and balanced so not too bad.

Have kept the old tyres as I may take them back as they were only 5 months old.

i would be taking them back aswell, cheap arse p.o.s. may i ask what brand they were just so when i go to buy next time, i know what to steer clear of....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • PranK
      Blue slip

      By PranK · Posted

    • GTSBoy
      Ethanol Content Sensor - Always at 11%?

      By GTSBoy · Posted

      But seriously, can we ask for the results of the "tip a bottle of metho into a nearly empty tank" experiment?
    • GTSBoy
      Blue slip

      By GTSBoy · Posted

      Hang on. Let me get this straight. The desire is to have coilovers, BC in particular, to be MORE comfortable on Sydney roads than stock suspension? Well, that's obviously not right. BCs have crude damping design at the very best, and typically hard spring rates. BC stands for Billy Cart. And then, the desire is to put in some shitty old worn out stockers, to get it blue slipped and then put the BCs back in? And then.....what? Not worry about getting pulled up by the Plod? Because you seem to have raised a worry about paying for engineering (which actually does solve all your legality problems) and still getting pulled up.... but the only problem there is that if/when that happens you have to show your paperwork at the inspection station. Whereas, if you just swap in borrowed shitty old stockers to get it slipped now, and then you get defected in the future, you have to go find more shitty old stockers then too. You course of action looks like this set of options: Buy brand new stock type dampers, and springs. probably cost a bit more than $1k all up, but will last for the remaining life of the car. Put them in, pass inspection, drive on them forever more. Hell, they could even be really nice Bilsteins and Kings or other lower&stiffer springs if you wanted. Get the car engineered as is. ~$1k. Buy new Shockworks coilvers (or MCA) and also pay for engineering. You're spending a lot more here. But these will be the best things that you could drive around on.
    • Dose Pipe Sutututu
      Blue slip

      By Dose Pipe Sutututu · Posted

      Might be worthwhile hitting up Facebook's groups, I know most of them contain terrible people and scammers - however you might be able to find someone that's in Sydney with factory suspension you could purchase and/or hire. Just do not send any form of money anywhere, in person cash only.
    • Stringycheese
      Blue slip

      By Stringycheese · Posted

      Thanks @Duncan Ride height is fine. I think it's almost stock tbh. Happy to share a pic. I don't actually have a regular mechanic as haven't lived in Sydney too long. Could you or anyone recommend any shops in Sydney?
×
×
  • Create New...