Jump to content
SAU Community

Recommended Posts

you sure its missing, i thought mine was so changed my plugs and coil packs was still doing it turned out to be the fuel pump acting up. get it on a dyno iam sure thay will tell you what the problem is.

Come to think of it, its kind of doing the boost cut or feul cut thing. it is boosting ok, but just sperts and carries on. Then at idle it just misses every now and then.

the only thing i have done is put a front mount in thats all

mate, i also have a similar problem and after 3 years am still searching for an answer...

i've got my eyes glued to this thread!

hahahah well im hoping someone will have an answer for me, driving to work today was ok until about 5 minutes from work it jerked alittle down low but up high is ok. i dont know what the issue is

its a common problem. Its the valve seats. What happens is you bring a car like a skyline to Australia and run it on the shitty fuel and it valve seats get dirty and every now and then a valve doesn't seat properly temporarily losing compression on that stroke.

The valves slowly rotate... therefore every now and then not seating properly.

if you want it to go away, take off your head and get a valve seat grind.

Other than that, just leave it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hard to say, just pop the rocker covers off and have a look if you think it's cammed. You probably need to replace the valve cover gasket/half moons anyways.
    • From my youth: GTi-R clutch change is a massive pain. The gearboxes are fragile? But the car is super cool and I want one 😢 
    • Remember this is 1988 tech.
    • Driveline vibration is resolved. I ended up loosening all my engine mount and trans mount bolts, giving it a good shake then retightening everything and it's gone... Let's just say I was surprised that fixed it.  I've been happily driving it around again but unfortunately put zero time into my direct port/constant pressure WMI setup. I'm on vacation next week, so I'll try and finalize it then.  On a different note, I spent all week fuel/ignition mapping 2x 216L V16 engines. Turbo's were burning glycol and we swapped them out for larger units. We also had planned emissions testing on site, so I figured I'd be there the same week to use their instrumentation and massage any emissions issues out if needed. This was a first for me. Fuel management is similar in certain ways to automotive (i.e air density as load variable) but very different in others. It's all PLC based and AFR's are controlled by air and not fuel. They use a control valve between the turbo and air manifold to control pressure which in turn controls AFR's. Due to this, target AFR tables supplied by the OEM are in pressures and not mass which really through me off. They use air pressure vs fuel pressure tables. I also relied on an O2 concentration sensor the emissions team had in the exhaust. Ignition timing was also all over the place and we were losing a fair bit of power. They're now happily sitting at 16-40BTDC depending on load. We were making about 1600kw at 900rpm at 90% load. Engines were running a lot smoother as well.    
    • heh, aint no R32 ever meeting modern targa cage rules unless the driver is veeeery short OP, good luck with the sale, since its already in the land of freedom I'm sure you will find a good buyer.
×
×
  • Create New...