Jump to content
SAU Community

R32 Gtst Stalling And Power Cutting Out

barnoon

By barnoon,
in Engines & Forced Induction

 Share

Recommended Posts

barnoon Experienced

barnoon

Posted
Posted

Hi guys been having problem with my R32 GTST lately, just some info on it first, stock turbo, gtr front mount, turbosmart bleed valve, pod filter, 3 inch turbo back exhaust, apexi bov.

The problem im having is very intermittent sometimes I can drive with no problems for a whole day ,ive only noticed it happening when the cars warm but sometimes when im around 2000rpm in any gear the car just loses all power, I can put my foot flat to the floor and nothing will happen and then all of a sudden it will jump to 3000rpm then no higher, sometimes after this happens I wait a few seconds then its fine other times it will then stall, when I try to restart the car it is very hard to start and needs me to rev it as its cranking over, sometimes once its restarted it will work fine again and sometimes the whole process will repeat itself, it can happen any time even while cruising along in say 4th the revs will just get stuck around 3k.

Ive also noticed since this problem started the car is idling quite low sometimes around 400rpm.

Any suggestions what it could be as its doing my head in,

thanks guys.

d0p3y Grand Master

d0p3y

Posted
Posted (edited)

Hey Guys,

Dave & I cleaned the AFM on his car last night. So far it seems a bit better but time will tell as it hasn't been taken for a good drive yet. Will let you know how that goes. If you have any further suggestions or comments let us know!

FYI; It's running 11psi.

Ryan

Edited by d0p3y

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...