Jump to content
SAU Community

Recommended Posts

4$k is PLENTY.. wanna waste money on brand parts fine. Want proven performance do it smart!

Exhausts = BATMBL for all the front stuff.. Get a catback on special from justjap or on the forums for like $300-500. Acid bath it or wash it out nice and proper and as long as it doesnt have any dents you'll be fine!

FMIC = Get a Calsonic made GTR. Good for about 250rwkw - probably less lag and better response than anything else for the price. Just get it cleaned up and flow tested etc if you're worried. $300-400 for the cooler.

HU = get a cheapie ebay unit. it's overseas model sure but you'll save a few hundred and it'll work just the same. Just make sure the radio frequency is tuned ok.

You have $2.5k left. Buy a whole stash of weed, coke and some whores.

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

$4,000 is a lot of money, i don't know if anyone has asked you but this is going into a R32 GTS-T right?

Just so we can get the engine right. RB20DET?!

if that is the case what i would do is get a GTR FMIC (instaled should be about $1000), there is no need to go with a SUPER FANCY FMIC if you are not going to be pushing the power, it is,IMO, a waste of money.

Get the Apex'i air filter (pod?)$150

good BOV (i have HKS SSQBOV and i like it)$150

upgrade the turbo to somthing special like a RB25 turbo ($500)

injectors 444CC Nismos are good for GTS-T's($400)

fuel pump (Walbro 255) In canada i got mine for $78.82 after tax

then upgrade the computer to a Emanage or the new Emanage Ultimate ($600)

This will bring you to $2900 so that will leave you with alittle music money!

I think that you will be pushing about 300HP to the ground with a setup like this and then you will be blowing all your fellow r32's away.

I think that this would even take a Stock GTR!

that is some food for thought!

I just realized that i did everything in Canadain dollars. so add 18% to everything and that is about the AUD conversion

$4,000 is a lot of money, i don't know if anyone has asked you but this is going into a R32 GTS-T right?

Just so we can get the engine right. RB20DET?!

if that is the case what i would do is get a GTR FMIC (instaled should be about $1000), there is no need to go with a SUPER FANCY FMIC if you are not going to be pushing the power, it is,IMO, a waste of money.

Get the Apex'i air filter (pod?)$150

good BOV (i have HKS SSQBOV and i like it)$150

upgrade the turbo to somthing special like a RB25 turbo ($500)

injectors 444CC Nismos are good for GTS-T's($400)

fuel pump (Walbro 255) In canada i got mine for $78.82 after tax

then upgrade the computer to a Emanage or the new Emanage Ultimate ($600)

This will bring you to $2900 so that will leave you with alittle music money!

I think that you will be pushing about 300HP to the ground with a setup like this and then you will be blowing all your fellow r32's away.

I think that this would even take a Stock GTR!

that is some food for thought!

I just realized that i did everything in Canadain dollars. so add 18% to everything and that is about the AUD conversion

doot....its a rb25det....a r34 :P

Nice Exhaust First With CAI and and pod with 1 of thos boxs on this forum $2-$2.5 thousand

FMIC with PBBOV $1.5 - $2 Thousand

Bleed value and Boost gauge$200 - $300

SAFC if any money left

as for music get a cd player with amp and some resonable 6x9s $1.5 thonsand all up

no need to go over board and you have an r34 and i recon you might keep it for a few years so you dont need to rush it all

James

Nice Exhaust First With CAI and and pod with 1 of thos boxs on this forum $2-$2.5 thousand

FMIC with PBBOV $1.5 - $2 Thousand

Bleed value and Boost gauge$200 - $300

SAFC if any money left

as for music get a cd player with amp and some resonable 6x9s $1.5 thonsand all up

no need to go over board and you have an r34 and i recon you might keep it for a few years so you dont need to rush it all

James

if my specialist maths is correct.....y=mx+c...carry the 1....yeh....all the above is kinda over 4k ahhaha

BOV is prob a waste of money, not really need unless you're running serious power.

Yeah, go to the suspension area, and check out SydneyKid's R34 Suspension kit. Bout $2.2K i think...

you can make your car faster without increasing the power. Full exhaust with some BATMBL parts is prob the only power upgrade i'd do with the money, the rest i'd spend on suspension, brakes, tyres, etc...

um... does the $4k have to spent on the car? maybe travel? some highly speculative shares? :yes: or just buy like $4k of ANZ shares, or something safe as houses...

id get:

apexi pod CAi and a box made up $300

batmbl front dump & cat$700 - find a 2nd hand jap brand cat back on these forums

then a Blitz or ARC front mount $1200: because the take stock piping route, i dont like the idea of drilling holes (i dont know if you can engineer them?)

thats about 2.2k

boost controller greddy profect B spec 2 $500

then a set of coil overs

and try and save a little more and get some decent tyres~ (G3's!!!)

Goodluck!

doesnt the PFC have boost controller built in? if he gets the hand controller with it, he wouldnt need an EBC. is the boost control function hard to use on th PFC? is a stand alone EBC much easier to use than a PFC. he needs a headunit to, he wants an alpine (forgot exact model) thats about $700

so far, he's only lookin at the baics, exhaust, cooler, PFC, boost. hows the fuel system hold up in 34's? wheres the limit of it, and how far will a pump upgrade go, as far as power levels with stock injectors etc. but between those mods, i guess he'd be lookin at around 220rwkw...

Edited by VB-

Come and see me, we can go for a drive in my car, I'll show you everything.

I'm in Melbourne.

I say, Suspension kit. $2.2k

Power FC with boost kit $1.3k

Full Exhaust inc BATMBL $1.0k

Hybrid Cooler Kit. $0.8k

That's a nice neat 4.3k.

Also, go to Racepace, get it tuned and make a solid 200rwkw, and the thing will handle too.

I reckon this is about the best bang for your buck combo so far, but I would change a few things:

Xforce full exhaust $950

Hybrid copy cooler kit $500

K&N pod filter + adaptor $100

2hnd rebuilt coilovers $1000

EBC $350

PFC w/ hand controller $960

Thats $3860 + tuning for the Power FC

3" front/dump + 3" high-flow cat - $270+190 (BATMBL)

3" cat back exhaust - $300 (secondhand off forum or eBay)

Hybrid copy FMIC - $200 (They're everywhere, some even cheaper)

IC piping - $200 - 300 (Have an exhaust place make it for you and use the factory piping route or just buy a full FMIC kit for $500 and cut up your car...)

POD and CAI - $200 (one of those ones with the perspex lid that Maxx was selling, or just make one yourself for about $50)

Turbotech boost controller - $40

PowerFC w/ controller - $950 (gR33ddy GB)

= $2450

say $500 for PFC tuning

= $2950

That leaves $1050 to spend on a HU or whatever. Personally I would spend it on a set of DBA slotted rotors for the front and some whiteline sway bars.

Edited by Lazy-Bastard
I reckon this is about the best bang for your buck combo so far, but I would change a few things:

3" front/dump + 3" high-flow cat - $270+190 (BATMBL)

3" cat back exhaust - $300 (secondhand off forum or eBay)

Hybrid copy FMIC - $200 (They're everywhere, some even cheaper)

IC piping - $200 - 300 (Have an exhaust place make it for you and use the factory piping route or just buy a full FMIC kit for $500 and cut up your car...)

POD and CAI - $200 (one of those ones with the perspex lid that Maxx was selling, or just make one yourself for about $50)

Turbotech boost controller - $40

PowerFC w/ controller - $950 (gR33ddy GB)

= $2450

say $500 for PFC tuning

= $2950

That leaves $1050 to spend on a HU or whatever. Personally I would spend it on a set of DBA slotted rotors for the front and some whiteline sway bars.

Game, Set and Match.....

theres your shopping list right there

proven bang for your buck items saving you alot of money also!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...