Jump to content
SAU Community

Recommended Posts

Hi,

I have an R33. The battery is completely flat. It does this if I haven't driven for around 3 weeks. Normally I jump start it though this time I can't move the car to a place where the leads reach another car.

I have bought a battery charger. It says I need to take the battery out of the car. So far I am having a lot of difficulty in getting the battery out of the boot.

My questions:

1) Can I jump start the car from the battery or does it have to go through the points in the engine bay?

2) If I can't jump start from the boot and I have to get the battery out, are there any tricks associated with getting the battery out?

Thanks

Link to comment
https://www.sau.com.au/forums/topic/111155-battery-problems/
Share on other sites

hey mate

from memory the only thing really holding the battery in is the steel bracket above it, and the terminals themselves.

take the terminals off, and then unscrew the little nut which will be holding the plate down on top of the battery...the steel rod running down the front will come loose and you should be able to move it out of the way and slip the battery out :thumbsup:

Yes you can jump from the battery but it is better to do from the points in the engine bay as they are closer to the engine (less loss).

You can disconnect the battery and charge it while it is in the boot. BTW how big is the battery???...I had a huge battery in there (commo/falcon sized) and had no trouble removing it.

3 weeks without driving it would kill most batteries when the car has a good alarm and some extra electrical add ons..

mines a 550CCA battery, and it'll die (well not enough to crank the car) after about 2 weeks.

jump start from the battery direct is fine too.

the batteries in most modern cars will die if you don't drive them for approx 2 to 3 weeks... the onboard computer modules etc constantly draw a small supply from the battery, and over time that drains it.

I work in a roadside assistance callcentre as a job, and you would not believe how many people call up and wonder why their battery is dead after going on a 3 week holiday etc...

oh, and i'll tell you the same thing that i tell my customers...

if the vehicle is jumpstarted, you need to drive the vehicle for approximately 45 minutes at highway speeds (or at higher revs, anyway) to put some charge back into the battery.

Leaving it idling in your driveway will NOT charge the battery

oh, and i'll tell you the same thing that i tell my customers...

if the vehicle is jumpstarted, you need to drive the vehicle for approximately 45 minutes at highway speeds (or at higher revs, anyway) to put some charge back into the battery.

Leaving it idling in your driveway will NOT charge the battery

i found out this out the hard way with my old car, thought i can start it up once every few days and let it sit idling for about 20 mins to re-charge battery, car started up for first few times than 2 weeks later, went to start, car just wont turn over.

don't know exactly how long it will last just sitting there, but i do know it would last a hell of a lot longer than if you left it connected :)

to prove this point, when i was doing some product training on one of the cars we cover the other night (Ferrari F430) they pointed out that this model has a battery isolator switch, which you turn to off if you go on holidays etc, this will stop the battery going flat while you're gone...

When my battery in the R33 went it took me over an hour to get it out and then at least another hour fitting the new battery as the new battery is a different size I had to adjust the brackets. Not to mention the time taken to unbolt the amp and subs in the boot to get to the battery.

Approx 3 hours, some blood, (knuckles and fingers from the damn bracket) sweat & tears (I was chopping onions earlier - nah just kidding) the new battery was finally in.

Good Luck :(

could be a short from dodgy wiring install...(Battery to boot relocation) If it stilll happens after your new batt may be an idea

R33 have battery in boot as standard.

Wet Standard (Sb/Sb) - High self-discharge rate (depending on the temperature, up to 50%-60% per month)

Wet "Maintenance Free" (Ca/Ca) - Up to 400% less self discharge

Sealed Absorbed Glass Mat (AGM) VRLA - Lower self-discharge rate (typically 1%-2% per month)

i'm looking up details for a new battery myself.

same battery that has been in my car since i got it 2.5 yrs ago. doesnt use the breather tube, has filler caps, to is illegal inside trunk.

thing plays up every 6months or so. leaving the headlights on for 15-20 saps enough to stop it cranking.

dont rely on racv, 60-90mins can turn into 2hrs++ as i found out.

racv dude puts negative clamp on the engine. shorter distance. dunno if it makes much difference. only other reason ive read, it to stop arcing near the battery in normal cars, as they battery can leak gas.

not looking forward to replacing cable clamps or battery cage =(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm back from the dyno - again! I went looking for someone who knew LS's and had a roller dyno, to see how it shaped up compared to everything else and confirm the powerband really is peaking where Mr Mamo says it should. TLDR: The dyno result I got this time definitely had the shape of how it feels on the road and finally 'makes sense'. Also we had a bit more time to play with timing on the dyno, it turns out the common practice in LS is to lower the timing around peak torque and restore it to max after. So given a car was on the dyno and mostly dialled in already, it was time for tweaking. Luis at APS is definitely knowledgable when it came to this and had overlays ready to go and was happy to share. If you map out your cylinder airmass you start seeing graphs that look a LOT like the engine's torque curve. The good thing also is if you map out your timing curve when you're avoiding knock... this curve very much looks like the inverse of the airmass curve. The result? Well it's another 10.7kw/14hp kw from where I drove it in at. Pretty much everywhere, too. As to how much this car actually makes in Hub Dyno numbers, American Dyno numbers, or Mainline dyno numbers, I say I don't know and it's gone up ~25kw since I started tinkering lol. It IS interesting how the shorter ratio gears I have aren't scaled right on this dyno - 6840RPM is 199KMH, not 175KMH. I have also seen other printouts here with cars with less mods at much higher "kmh" for their RPM due Commodores having 3.45's or longer (!) rear diff ratios maxing out 4th gear which is the 1:1 gear on the T56. Does this matter? No, not really. The real answer is go to the strip and see what it traps, but: I guess I should have gone last Sunday...
    • 310mm rotors will be avilable from Australia, Japan, and probably a few other places. Nothing for the front can be put on the back.
    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
×
×
  • Create New...