Jump to content
SAU Community

Recommended Posts

HI ALL

I HAVE THESE PARTS FOR SALE

1X R33 GTST SERIES 1 GENUINE M-SPEC PLASTIC FRONT BAR IN WHITE NO DAMAGE OR MARKS $500

2X R33 FRONT TURBO CALLIPERS 30MM AND 296MM ROTORS IN ECELLENT CONDITION THE LOT $400

2X R33 REAR TAIL LIGHTS COMPLETE LIKE NEW PAIR $280

1X R33 GTST STANDARD TURBO RB25 SERIES 1 ONLY 56000KMS NO SHAFT PLAY $500

1X R33 COUPE MASTER DOOR/WINDOW SWITCH $200

1X Q45 90MM BIG AIR FLOW METER $200

2X R33 REAR TURBO VENTILATED ROTORS PAIR $150

1X STANDARD BLOW OFF VALVE PLUM BACK $40

1X STANDARD AIR BOX WITH SNORKLE LIKE NEW $200

1X ENGINE FAN (NO VISCUS) VERY CLEAN WHITE LIKE NEW GOOD FOR SHOW CAR $150

1X R33 COUPE REAR PARCEL SHELF GOOD CONDITION $50

1X FRONT POWER STEERING RACK COMPLETE WITH TIE ROD ENDS $200

2X DOOR TRIMS LEFT AND RIGHT GOOD CONDITION $100 EACH

4X STANDARD SUSPENSION SPRINGS FOR FRONT AND BACK GTST $100 THE LOT

2X SERIES 1 BAR INDICATORS PAIR $80

ALL NEGOTIOABLE OPEN TO OFFERS AND WILL POST (AT COST)

CALL ON 0419777522 OR PM

Edited by Hooman
  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...